欢迎访问ic37.com |
会员登录 免费注册
发布采购

LR8N8-G 参数 Datasheet PDF下载

LR8N8-G图片预览
型号: LR8N8-G
PDF下载: 下载PDF文件 查看货源
内容描述: 高输入电压可调三端线性稳压器 [High Input Voltage Adjustable 3-Terminal Linear Regulator]
分类和应用: 稳压器调节器输出元件
文件页数/大小: 9 页 / 693 K
品牌: SUPERTEX [ Supertex, Inc ]
 浏览型号LR8N8-G的Datasheet PDF文件第2页浏览型号LR8N8-G的Datasheet PDF文件第3页浏览型号LR8N8-G的Datasheet PDF文件第4页浏览型号LR8N8-G的Datasheet PDF文件第5页浏览型号LR8N8-G的Datasheet PDF文件第6页浏览型号LR8N8-G的Datasheet PDF文件第7页浏览型号LR8N8-G的Datasheet PDF文件第8页浏览型号LR8N8-G的Datasheet PDF文件第9页  
LR8
High Input Voltage
Adjustable 3-Terminal Linear Regulator
Features
13.2V to 450V input voltage range
Adjustable 1.20V to 440V output regulation
5% output voltage tolerance
Output current limiting
10µA typical ADJ current
Internal junction temperature limiting
General Description
The Supertex LR8 is a high voltage, low output current,
adjustable linear regulator. It has a wide operating input
voltage range of 13.2V to 450V. The output voltage can be
adjusted from 1.20V to 440V provided that the input voltage
is at least 12V greater than the output voltage. The output
voltage can be adjusted by means of two external resistors
R1 and R2 as shown in the typical application circuits. The
LR8 regulates the voltage difference between VOUT and ADJ
pins to a nominal value of 1.20V. The 1.20V is amplified by
the external resistor ratio R1 and R2. An internal constant bias
current of typically 10µA is connected to the ADJ pin. This
increases V
OUT
by a constant voltage of 10µA times R2.
The LR8 has current limiting and temperature limiting. The
output current limit is typically 20mA and the minimum
temperature limit is 125°C. An output short circuit current will
therefore be limited to 20mA. When the junction temperature
reaches its temperature limit, the output current and/or output
voltage will decrease to keep the junction temperature from
exceeding its temperature limit. For SMPS start-up circuit
applications, the LR8 turns off when an external voltage
greater than the output voltage of the LR8 is applied to VOUT
of the LR8. To maintain stability, a bypass capacitor of 1.0µF
or larger and a minimum DC output current of 500µA are
required.
The device is available in TO-243AA (SOT-89), TO-252 (D-
PAK), and TO-92 packages.
Applications
Off-line SMPS startup circuits
Adjustable high voltage constant current source
Industrial controls
Motor controls
Battery chargers
Power supplies
Typical Application Circuit
*
V
OUT
VIN
VIN
V
OUT
ADJ
R1
C2
R2
R
LOAD
LR8
C1
*Required for conditions where V
IN
is less than V
OUT
.