Technical
S pecification
DQ65033QMA06
48V in
Input
5.0/3.3V
Outputs
60 Watt
Power
2000Vdc
Isolation
Quar ter-brick
DC/DC Conver ter
Th e DQ 6503 3QM A06 D ua lQ or
™
Me g a se ri e s i s a du al
o ut p u t co nv er t er t h at us es th e ind u st r y s t an d ar d q u ar t er b r ick
p a ckage siz e. Th e ver y high efficie ncy is a re su lt o f
S yn Q or ’s p aten ted top ol ogy tha t u se s sy nc hr on ou s re ctifica -
tio n an d an inn ovative co ns tru ction des ign to min imize h eat
d is sip a t ion an d al lo w ext r emel y h igh po wer d en s iti es. Th e
p owe r d is si pa ted b y th e c onver ter is so l ow th at a h ea tsin k
is no t r eq ui red , whi ch s aves cos t, weigh t, h eigh t, an d a p pl i -
c at io n e ffor t . A ll of t h e p owe r a n d con t ro l c omp on en ts a r e
mo u nted to th e m ul ti-l a yer PCB s ub str a te with h igh -y iel d s ur -
fa ce mo un t tech n olo gy , r es ul ting in a mor e rel ia bl e pr od u ct.
Dual Output
Operational Features
• Very high efficiency, >90% at full rated load current
• Delivers up to 60 Watts of output power with minimal
derating - no heatsink required
• Wide input voltage range: 35V – 75V, with 100V
100ms input voltage transient capability
• Fixed frequency switching provides predictable EMI per-
formance
• No minimum load requirement means no preload resis-
tors required
DQ65033QMA06 Module
Pr otection Features
• Input under-voltage lockout disables converter at low
input voltage conditions
• Output current limit and short circuit protection protects
converter and load from permanent damage and conse-
quent hazardous conditions
• Active back bias limit prevents damage to converter
from external load induced pre-bias
• Output over-voltage protection protects load from dam-
aging voltages
• Thermal shutdown protects converter from abnormal
environmental conditions
Mechanical Features
• Industry standard pin-out configuration
• Industry standard size: 1.45” x 2.3” (36.8x58.4mm)
• Total height less than 0.43” (10.9mm), permits better
airflow and smaller card pitch
• Total weight: 1.5 oz. (43 g)
• Flanged pins designed to permit surface mount solder-
ing (avoid wave solder) using FPiP technique
Safety Features
• 2000V, 30 MΩ input-to-output isolation provides
input/output ground separation
• UL/cUL 60950 recognized (US & Canada), basic insu-
lation rating
• TUV certified to EN60950
• Meets 72/23/EEC and 93/68/EEC directives which
facilitates CE Marking in user’s end product
• Board and plastic components meet UL94V-0 flammabil-
ity requirements
Contr ol Features
• On/Off control referenced to input side (positive and
negative logic options are available)
• Output voltage trim: +10%/-10%, permits custom volt-
ages and voltage margining
Product # DQ65033QMA06
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-2DQ653E Rev. H
7/7/04
Page 1
SYNQOR [ SYNQOR WORLDWIDE HEADQUARTERS ]
