Technical Specification
Eighth
Brick
MECHANICAL
DIAGRAM
0.14
0.150
(3.81)
(3.56)
48Vin 1.5Vout 15A
2.30
(58.42)
2.00
(50.8)
0.150
(3.81)
0.300
0.90
(22.86)
0.600
(15.24)
(7.62)
Top View
0.300
(7.62)
0.450
(11.43)
0.600
(15.24)
0.335
Bottom side
Clearance
See Note 9
(8.5)
0.019 +0.013
(0.48 +0.33)
Side View
Lowest
Component
Load Board
0.110
(2.79)
See Note 3
NOTES
1) Pins 1-3, 5-7 are 0.040” (1.02mm) diameter. with
0.080” (2.03mm) diameter standoff shoulders.
2) Pins 4 and 8 are 0.062” (1.57 mm) diameter with
0.100” (2.54 mm) diameter standoff shoulders.
3) Other pin extension lengths available. Recommended pin
length is 0.03” (0.76mm) greater than the PCB thickness.
4) All Pins: Material - Copper Alloy
Finish - Tin/Lead over Nickel plate
5) Undimensioned components are shown for visual
reference only.
6) All dimensions in inches (mm)
Tolerances: x.xx +/-0.02 in. (x.x +/-0.5mm)
x.xxx +/-0.010 in. (x.xx +/-0.25mm)
7) Weight: 0.68 oz. (19 g) typical
8) Workmanship: Meets or exceeds IPC-A-610C Class II
9)
UL/TUV standards require a clearance greater than 0.04”
(1.02mm) between input and output for Basic insulation. This
issue should be considered if any copper traces are on the top
side of the user’s board. Note that the ferrite cores are consid-
ered part of the input/primary circuit.
PIN CONNECTIONS
Pin No.
1
2
3
4
5
6
7
8
Notes:
1. Pin 5 must be connected to Vout(-).
2. Leave Pin 6 open for nominal output voltage.
3. Pin 7 must be connected to Vout(+).
Name
Vin(+)
ON/OFF
Vin(-)
Vout(-)
SENSE(-)
TRIM
SENSE(+)
Vout(+)
Function
Positive input voltage
TTL input to turn converter
on and off, referenced to
Vin(-), with internal pull up.
Negative input voltage
Negative output voltage
Negative remote sense
1
Output voltage trim
2
Positive remote sense
3
Positive output voltage
Product # PQ60015EML15
Phone 1-888-567-9596
Doc.# 005-2EM651E Rev. B
9/3/03
Page 2
SYNQOR [ SYNQOR WORLDWIDE HEADQUARTERS ]
