C2510Fx / CC2511Fx
0xDF1E: FSCAL1 – Frequency Synthesizer Calibration
Bit Field Name
Reset
R/W
Description
7:6
-
R0
Not used
5:0 FSCAL1[5:0]
100000
R/W
Frequency synthesizer calibration result register. Capacitor
array setting for VCO coarse tuning.
Fast frequency hopping without calibration for each hop can
be done by calibrating upfront for each frequency and saving
the resulting FSCAL3, FSCAL2and FSCAL1register values.
Between each frequency hop, calibration can be replaced by
writing the FSCAL3, FSCAL2and FSCAL1register values
corresponding to the next RF frequency.
Note: This register will be in its reset state when returning to active mode from PM2 and PM3.
0xDF1F: FSCAL0 – Frequency Synthesizer Calibration
Bit Field Name
Reset
R/W
Description
7
-
R0
Not used
6:0 FSCAL0[6:0]
0001101
R/W
Frequency synthesizer calibration control. The value to use in this
register is given by the SmartRF® Studio software [8].
0xDF23: TEST2 – Various Test Settings
Bit Field Name
Reset
R/W
Description
7:0 TEST2[7:0]
0x88
R/W
For improved sensitivity at low data rates (≤100 kBaud) this register
can be written to 0x81. The temperature range is then from 0 oC to
+85 oC.
0xDF24: TEST1 – Various Test Settings
Bit Field Name
Reset
R/W
Description
7:0 TEST1[7:0]
0x11
R/W
Must be written to 0x31.
For improved sensitivity at low data rates (≤100 kbps) this register can
be written to 0x35.The temperature range is then from 0 oC to +85 oC.
0xDF25: TEST0 – Various Test Settings
Bit Field Name
Reset
R/W
Description
The value to use in this register is given by the SmartRF® Studio
software [8].
7:2 TEST0[7:2]
000010
R/W
1
0
VCO_SEL_CAL_EN
TEST0[0]
1
1
R/W
R/W
Enable VCO selection calibration stage when 1
The value to use in this register is given by the SmartRF® Studio
software [8].
0xDF2E: PA_TABLE0 – PA Power Setting
Bit Field Name
Reset
R/W
Description
7:0 PA_TABLE0[7:0]
0x00
R/W
Power amplifier output power setting
SWRS055D
Page 227 of 243
TAOS [ TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS ]
