C2510Fx / CC2511Fx
Component
C301
C203/C214
C202
C212
C213
C201, C211
C231, C241
C171, C181
C232, C242
C233
C234
L231, L232, L241
L281
R271
R264
R262/R263
X1
X2
X3
X4
Value
1 µF ±10%, 0402 X5R
33 pF
56 pF
10 nF
33 pF
27 pF ±5%, 0402 NP0
100 pF ±5%, 0402 NP0
15 pF ±5%, 0402 NP0
1.0 pF ±0.25 pF, 0402 NP0
1.8 pF ±0.25 pF, 0402 NP0
1.5 pF ±0.25 pF, 0402 NP0
1.2 nH ±0.3 nH, 0402 monolithic, Murata LQG-15 series
470 nH ±10%, Murata LQM18NNR47K00
56 kΩ ±1%, 0402
1.5 kΩ ±5%
33
Ω
±2%
26.0 MHz surface mount crystal
32.768 kHz surface mount crystal (optional)
48.0 MHz surface mount crystal (fundamental)
48.0 MHz surface mount crystal (3 overtone)
rd
Table 29: Bill Of Materials for the CC2510Fx/CC2511Fx Application Circuits (subject to changes)
10.6 PCB Layout Recommendations
The top layer should be used for signal routing,
and the open areas should be filled with
metallization connected to ground using
several vias.
The area under the chip is used for grounding
and shall be connected to the bottom ground
plane with several vias for good thermal
performance and sufficiently low inductance to
ground. In the CC2510EM reference designs
attached pad. These vias should be “tented”
(covered with solder mask) on the component
side of the PCB to avoid migration of solder
through the vias during the solder reflow
process.
The solder paste coverage should not be
100%. If it is, out gassing may occur during the
reflow process, which may cause defects
(splattering, solder balling). Using “tented” vias
reduces the solder paste coverage below
100%.
See Figure 13 for top solder resist and top
paste masks recommendations.
Each decoupling capacitor should be placed
as close as possible to the supply pin it is
supposed to decouple. The best routing is from
the power line to the decoupling capacitor and
then to the
CC2510Fx
supply pin. Supply power
filtering is very important.
Each decoupling capacitor ground pad should
be connected to the ground plane using a
separate via. Direct connections between
neighboring power pins will increase noise
coupling and should be avoided unless
absolutely necessary.
The external components should ideally be as
small as possible (0402 is recommended) and
surface
mount
devices
are
highly
recommended. Please note that components
smaller than those specified may have differing
characteristics.
Schematic, BOM, and layout Gerber files are
all available from the TI website for both the
CC2510EM reference design [1] and the
CC2511 USB Dongle reference design [2].
SWRS055D
Page 37 of 243
TAOS [ TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS ]
