Typical RF Characteristics
-0.00
-0.25
-0.50
INSERTION LOSS IN dB
-0.75
-1.00
-1.25
-1.50
-1.75
-2.00
-2.25
-2.50
0
500
1,000
1,500
2,000
2,500
3,000
3,500
Frequency (MHz)
4,000
4,500
5,000
5,500
6,000
INSERTION LOSS (RF Note 1)
1.50
1.45
1.40
1.35
1.30
1.25
1.20
1.15
1.10
1.05
1.00
0
VSWR
500
1,000
1,500
2,000
2,500
3,000
3,500
Frequency (MHz)
4,000
4,500
5,000
5,500
6,000
0
-5
-10
-15
-20
-25
-30
-35
-40
-45
-50
-55
-60
-65
-70
ISOLATION (RF Note 2)
ISOLATION IN dB
0
500
1,000
1,500
2,000
2,500
3,000
3,500
Frequency (MHz)
4,000
4,500
5,000
5,500
6,000
RF Notes:
1. Data represents an average between the typical reading of pins 8 and 6 (closed, coil A last energized) and pins 8 and 1
(closed, coil B last energized)
2. Data represents an average between the typical reading of pins 8 and 6 (open, coil B last energized) and pins 8 and 1 (open,
coil A last energized)
3. Test conditions:
a.
Fixture: .031” copper clad, reinforced PTFE, RT/duroid
®
6002 with SMA connectors. (RT/duroid
®
is a
registered trademark of Rogers Corporation).
b.
Relay header is in contact with but not soldered to ground plane nor connected to ground via ground pin.
c
.
Test performed at room ambient temperature.
d.
Terminals not tested were terminated with 50 ohm load.
e.
Contact signal level: 20 dBm.
4. Data presented herein represents typical characteristics and is not intended for use as specification limits.
TELEDYNE [ TELEDYNE TECHNOLOGIES INCORPORATED ]
