TRCM Chip Wirewound Inductors
TOKEN
TRCM322522, TRCM453232 - Mechanical Performance Test
REQUIREMENTS
Terminal Strength
CHARACTERISTICS
No evidence of damage
TEST METHOD(DIS C 5321)
Terminals shall withstand a pull of 0.5Kgf
in a horizoninal direction
2 hours in each direction of X,Y,Z on p-Board
at a frequency range of 10-55-10HZ with
1.5mm amplitude
Δ L/L shall be within ±3%.
No evidence of damage
Vibration
Dropping
Δ L/L shall be within ±3%.
No evidence of damage
Dropping 1m over the ground of conctete or
cement
TRCM322522, TRCM453232 - Electrical Performance Test
REQUIREMENTS
CHARACTERISTICS
TEST METHOD(JIS C 5321)
No evidence of damage
Δ L/L shall be within ±3%
Immerse in the solder (H63A) of 260±5°C for
10±1sec, leave for 2hrs at normal TEMP
Resistance to Soldering Heat
More than 90% surface to
be covered with new soldering
Solderability
AV100V 60 SEC.
Dielectric with
standing voltage
No veridence of breakdown
resistor 1000 Mohm and over
DC500V 30 SEC.
DC 500V 30 SEC.
Insulation Resistance
No veidence of breakdown,
resistor 1000 Mohm and over
TRCM322522, TRCM453232 - Climatic Test
REQUIREMENTS
CHARACTERISTICS
TEST METHOD(JIS C 5321)
No evidence of damage,
Δ L/L within ±5%,
Q/Q within ±30%
Immerse in the solder (H63A)of 260±5°C
for 10±1sec, leave for 2hrs at normal TEMP.
LOW TEMP. Characteristics
Keep for 30 min. at TEMP.of -25°C~+85°
Cat 5 cycle case of TEMP. change from low to high
and V.V.
No evidence of damage,
Δ L/L within ±5
TEMP. Cycling
Δ L/L to be measured at the temperature
of between -25°C and +85°C
Temperature Characteristics
Moiisture load Characteristics
Δ L/L within ±3%
No evidence of damage,
Δ L/L within ±5%,
Q/Q within ±30
TEMP.40±2°C,Humidity 90~95% 96± 2hrs,
measurements shall be performed after 1~2hrs at
normal TEMP..
Leave for 96±2hrs in a bath of
TEMP.85±2°C,measurements shall be performed
after 1~2hrs at normal TEMP.
High TEMP. overload
Characteristics
No evidence of damage,Δ L/L
within ±5%,Q/Q within ±30
06 of 07
Version 2010
rfq token.com.tw
http://www.token.com.tw/
TOKEN [ TOKEN ELECTRONICS INDUSTRY CO., LTD. ]
