BUS I N T E R F A C E C O N V E R TE R S
I N T E R FA CES
US B-
2
-X
USB
t o C A N, I I C , R S 4 8 5 , S P I , LIN
I n t e r f a ce C o n v e r t e r
10 m m
M A IN CH A R AC T ER IS T IC S
INFO
The Engineer´s „Swiss Army Knife“ for Serial Bus Systems
The USB-2-X device is an interface converter that is equipped
with a CAN interface, an IIC interface, a LIN interface, an SPI
interface and an RS-485 interface. It is connected to the PC via
an USB interface. The USB-2-X device is mainly designed for
use with some of the Trinamic evaluation kits, but it can also
be used in any other purpose where a connection between a
PC and a CAN interface, an IIC interface, a LIN interface, an SPI
interface or an RS485 interface is needed. The software sup-
plied with this product can be used with every version of the
Windows operating system that supports USB (Windows 98,
Windows ME, Windows 2000, Windows XP). The USB-2-X device
can be connected to USB 1.1 or USB 2.0 hosts and supports the
full bitrate of 12MBit/s. It is fully powered by the bus, so no
extra power supply is needed.
• U SB host interface
connection to USB 1.1 or USB 2.0 hosts
possible (a cable is included)
USB full speed device (12MBit/s)
bus powered (no extra power supply
needed)
• CAN
CAN 2.0A and 2.0B compatible
standard (11 bit) and extended (29 bit)
identifier possible
transceiver: ISO 11898 compatible
maximum bit rate: 1MBit/s
120 ohms termination resistor can be
activated with a jumper
• L IN
compatible with LIN specification rev 1.3
up to 20kBit/s
Industry standard transceiver
• I ²C
single master
up to 400kBit/s
7-bit addressing
• RS - 4 85
· half duplex communication mode
· industry standard 75176 transceiver
· 2400, 9600 and 19200 bps supported
• SPI
· master functionality
· user defined bit rate up to 3.7MBit/s
• Ro HS compliant
USB2X
USB
CAN
IIC
LIN
SPI
RS-485
ORDER CODE
DESC R IP T IO N
TMC USB-2-X V2
USB interface converter (with USB cable)
www.trinamic.com
– for detailed information and datasheets
63