TRUMPower
D E SCR IPTION
The TFC130 series incorporates creative high
efficiency circuitry, high power density (6.94
3
Watts/in ) and active Power Factor Correction
(PFC) to meet the requirements of data
networking, computing and telecommunication
systems. Some models with one or two outputs
adjustable between 5V and 24V intend to suit
more applications.
PFC 130 WATT POWER SUPPLIES
TFC130 SERIES
(MULTIPLE OUTPUT)
(LVD)
RoHS
F EATU R E S
‧
‧
‧
‧
‧
‧
‧
‧
‧
‧
EN61000-3-2 class A and D compliant
Pow er factor 0.98 typical
Ve r y c o m pa c t s i z e , 3
″
× 5
″
× 1 . 2
″
O v e r v o l ta g e p r o t e c t i o n
Short circuit protection
Remote sense on 3.3V output
Pow er Good/Pow er Fail Detect Signal
U p t o f i v e D C o u t p u ts
A l l o u t p u ts w e l l r e g u l a t e d
C o m p l i a n t w i t h R o H S r e q u i r e m e n ts
Saf et y Sta n da rd A ppr o va ls：
UL 60950 3
rd
CSA C22.2 No. 60950 3rd
TÜV EN60950-1
IN PUT S PE C IF ICAT ION S
Input voltage：
Input frequency：
Input current：
Earth leakage current:
(Touch Current)
90 to 264VAC
47 to 63Hz
2.1A（ rms）max. for 115VAC
1.1A（ rms）max. for 230VAC
0.3mA max. @ 115VAC, 60Hz
0.6mA max. @ 230VAC, 50Hz
E N V IR O N M ENTA L SP E C IF ICATI O N S
Operating temperature
：
Storage temperature
：
Relative humidity
：
Derating
：
Cooling
：
-10ºC to +60ºC
-40ºC to +85ºC
5% to 95% non-condensing
Derate from 100% at +40ºC
linearly to 50% at +60ºC
10 CFM total forced air
from two 40mm diameter
fans or the like is required
a n d p r o v i d e d b y u s e r.
OUTPUT SPECIFICATIONS
Output voltage/current：
Ripple and noise：
See Rating Chart
65mV peak to peak on V1,1%
peak to peak on other outputs
GENERAL SPECIFICATIONS
100KHz ±10KHz
0.98 typical
75% typical
15 msec minimum at 115VAC
±0.5% maximum at full load
35 amps @ 115VAC or 70 amps
@ 230VAC at 25ºC cold start
Withstand voltage：
3000VAC from input to output
1500VAC from input to ground
500VAC from output to ground
MTBF：
200,000 hours minimum
EMC Performance (EN55024)
EN55022:
Class B conducted, class A radiated
FCC Part 15
Class B conducted, class A radiated
VCCI:
Class B conducted, class A radiated
EN61000-3-2:
Harmonic distortion, class A and D
EN61000-3-3:
Line flicker
EN61000-4-2:
ESD, ±8KV air and ±4KV contact
EN61000-4-3:
Radiated immunity, 3V/m
EN61000-4-4:
Fast transient/burst, ±1KV
EN61000-4-5:
Surge, ±1KV diff, ±2KV com.
EN61000-4-6:
Conducted immunity, 3Vrms
EN61000-4-8:
Magnetic field immunity, 1A/m
E N 6 1 0 0 0 - 4 - 11 :
Voltage dips, 30% reduction for
500ms and >95% reduction for 10ms
Switching frequency：
Power factor：
Efficiency：
Hold-up time：
Line regulation：
Inrush current：
Overvoltage protection：
Provided on V0 & V1; set at
112–132% of its nominal
output voltage
Overcurrent protection：
All outputs protected to short
circuit conditions
Temperature coefficient：
All outputs ±0.04/ºC maximum
Transient response：
Maximum excursion of 4%
or better on all models,
recovering to 1% of final
value within 500µs after
a 25% step load change
TTL logic high for normal
operation and TTL logic low
upon loss of input power.
This signal appears at least
10ms prior to master output
dropping 5% below its
nominal value. This signal
also provides a minimum
delay of 100ms after master
output is within regulation
PG/PFD signal：
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Bldg. 13, Santa Clara, California 95054, USA
Phone: 408-988-6616
●
Fax: 408-988-6622
●
email: sales@trumpower.com
●
Website: www.TRUMPower.com
TRUMPOWER [ Tumbler Technologies + TRUMPower ]
