UN13750
Programmable
Encoder/Decoder
Single chip contains both Encoder and Decoder.
3V to 11 V operation.
On chip oscillator uses non-critical RC components.
Cross interference of recetver is virtually eliminated
by circuitry which requires 4 valid words to be received,
each within 64ms of the other.
Schmitt Trigger input provides excellent noise immunity.
Applications.
alarm control system, security system
cordless telephone, remote control.
Interfaces with RF, ultrasonic, or infrared modulators I
and demodulators
General Description
T h e U M 3 7 5 0 E n c o d e r / D e c o d e r
is a CMOS/LSI digital
code Transmitter-Receiver system. Working in the trans-
mit (encoder) mode, the UM3750 will sequentially encode
and transmit 12 bits of input. Each of the 12 bits may
be 1 or 0 to allow 4096 different codes.
In the
receive (decoder)
mode, the incoming signal is
Once
IS
compared to the local code In a sequential manner
an error
comparison on the next word. If all 12 bits are received
correctly, a “valid” signal is generated. This signal clears a
64ms counter and triggers a 3-stage counter. The 3-stage
counter counts the “valid” pluses and when 4 pulses have
been detected, the TX/RX output pin goes low. After the
TX/RX output pin goes low, the next “valid” must be
received within 128ms, giving a one valid in 6 requirement
to keep the TX/RX output pin.
detected the system will reset and beain its
Pin Configurations
“cc
“cc
TX/RX OUTPUT
RECEIVER INPUT
MODE SELECT
“ss
R.C INPUT
A12
All
A10
TX/RX
OUTPUT
RECEIVER INPUT
MODE SELECT
“SS
R.C. INPUT
A12
All
A10
NC
2-3
UMC [ UMC CORPORATION ]
