C-TYPE Data Sheet
Table 2. Electrical Performance, 3.3V option
Parameter
Symbol
Min
0.012
2.97
-0.5
Typical
Maximum
190.000
3.63
Units
MHz
V
V
mA
Frequency
fO
VDD
1
Operating Supply Voltage
Absolute Maximum Operating Voltage
Supply Current, Output Enabled
< 1.500 MHz
3.3
5.0
IDD
5
1.5 to 20 MHz
7
20.01 to 50 MHz
50.01 to 85 MHz
85.01 to 190 MHz
20
30
50
30
Supply Current, Output disabled
Output Logic Levels
IDD
uA
Output Logic High2
VOH
VOL
IOH
IOL
tR/tF
0.9*VDD
V
V
mA
mA
ns
Output Logic Low2
0.1*VDD
Output Logic High Drive
Output Logic Low Drive
Output Rise/Fall Time2
< 1.00 MHz
8
8
200
6
1.00 to 20.00 MHz
20.01 to 50.00 MHz
4
50.01 to 90.00 MHz
3
90.01 to 190.00 MHz
Duty Cycle3 (ordering option)
Operating Temperature (ordering option)
Storage Temperature
Stability4 (ordering option)
RMS Jitter, 12kHz to 20 MHz
RMS Jitter
2
SYM
45/55
-10/70 or –40/85
%
°C
°C
ppm
ps
-55
125
±20, ±25, ±32, ±50, ±100
0.5
2.5
1
ps
V
Output Enable/Disable5
Output Enabled
2.0
Output Disabled
0.5
10
Internal Enable Pull-Up resistor5
Start-up time
100
Kohm
ms
1. A 0.01uF and a 0.1uF capacitor should be located as close to the supply as possible (to ground) is recommended.
2. Figure 3 defines these parameters. Figure 4 illustrates the operating conditions under which these parameters are tested and
specified. For Fo>90MHz, rise and fall time is measured 20 to 80%.
3. Symmetry is measured defined as On Time/Period.
4. Includes calibration tolerance, operating temperature, supply voltage variations, aging and shock and vibration (not under
operation).
5. Output will be enabled if enable/disable is left open.
tR
tF
IDD
VOH
50%
VOL
4
1
+
-
3
.1mF
.01mF
2
VDD
IC
V C
On Time
15pF
+
-
Period
Figure 3. Output Waveform
Figure 4. Typical Output Test Conditions (25±5°C)
Vectron International 267 Lowell Rd, Hudson NH 03051
Tel: 1-88-VECTRON-1
e-mail vectron@vectron.com
VECTRON [ Vectron International, Inc ]
