LV12S20-100-S 参数 Datasheet PDF下载

Rev. D

TECHNICAL DATASHEET

LV12S20-100

Paralleling Converters

The LV series converters may be paralleled both for redundancy and for higher output current. However, in order

to do this, a high-current, low V

f

, schottky diode must be placed at the +Vo pin of each supply as shown in Figure

6. To improve sharing, tie the two TRIM pins together. The converters may be trimmed by adding a resistor value

from Table 2 from each TRIM pin to

±RS

pin, or alternatively, a single resistor of half the value of Table 2 from

the common TRIM pins to the common

±RS

pins.

Figure 6: Paralleling Converters

(888) 597-WALL

www.wallindustries.com

Page 7 of 15