WSH413
Hall Effect Sensor IC with Thermal Lock Protection
and Auto Restart Function
Features:
Operate from 2.8V to 36V supply voltage.
On-chip Hall sensor.
Internal bandgap regulator allows temperature compensated operations and a
wide operating voltage range.
High output sinking capability up to 500mA for driving large load.
Lower current change rate reduces the peak output voltages during switching.
Available in rugged low profile SOT-25 , SIP-4L packages.
Built-in
PWM
Speed Control function .
Built-in protection diode for reverse power supply fault.
Built-in
thermal lock protection
and
auto-restart
function.
General Description:
WSH413 is designed to integrate Hall sensor with complementary output drivers and
frequency generator together on the same chip, it is suitable for speed measurement,
revolution counting, positioning, and DC brushless motors. It includes a temperature
compensated voltage regulator, a differential amplifier, a Hysteresis controller, two
Darlington output drivers capable of sinking 500mA current load and an PWM signal
input pin capable of doing speed control. An on-chip protection diode is implemented
to prevent reverse power fault. And built-in
thermal lock protection
and
auto-restart
function is suitable for super high speed fan. It can replace the function of lock
protection and auto restart function. The power will be shutdown automatically at
125°C to prevent the coils be damaged and auto-restart after cooling down 5~10°C
when thermal protected was activated .
The temperature-dependent bias increases the supply voltage of the hall plates and
adjusts the switching points to the decreasing induction of magnets at higher
temperatures. Subsequently, the open collector output switches to the appropriate state.
WSH413 are rated for operation over temperature range from
–20˚
C to 100˚C and
voltage ranges from 2.8V to 36V.
Winson reserves the right to make changes to improve reliability or manufacturability.
©Winson,
2005/10/31
WINSON [ WINSON SEMICONDUCTOR CORP. ]
