AG402-86
InGaP HBT Gain Block
The Communications Edge
TM
Product Information
This package is lead-free/Green/RoHS-compliant. It is compatible with both lead-free (maximum 260
°C
reflow temperature) and leaded
(maximum 245
°C
reflow temperature) soldering processes. The plating material on the pins is annealed matte tin over copper.
AG402-86G (Green / Lead-free Sot-86 Package) Mechanical Information
Outline Drawing
Product Marking
The component will be marked with a “Y”
designator followed by a two-digit numeric lot
code on the top surface of the package. The
obsolete tin-lead package is marked with an
“F” designator followed by a two-digit numeric
lot code.
Tape and reel specifications for this part are
located on the website in the “Application
Notes” section.
MSL / ESD Rating
ESD Rating:
Value:
Test:
Standard:
Class 1C
Passes
≥
1000V min.
Human Body Model (HBM)
JEDEC Standard JESD22-A114
Class IV
Passes
≥
1000V min.
Charged Device Model (CDM)
JEDEC Standard JESD22-C101
Land Pattern
ESD Rating:
Value:
Test:
Standard:
MSL Rating: Level 3 at +260
°C
convection reflow
Standard:
JEDEC Standard J-STD-020
Mounting Config. Notes
1. Ground / thermal vias are critical for the proper
performance of this device. Vias should use a .35mm
(#80 / .0135”) diameter drill and have a final plated thru
diameter of .25 mm (.010”).
2. Add as much copper as possible to inner and outer layers
near the part to ensure optimal thermal performance.
3. Mounting screws can be added near the part to fasten the
board to a heatsink. Ensure that the ground / thermal via
region contacts the heatsink.
4. Do not put solder mask on the backside of the PC board in
the region where the board contacts the heatsink.
5. RF trace width depends upon the PC board material and
construction.
6. Use 1 oz. Copper minimum.
7. All dimensions are in millimeters (inches). Angles are in
degrees.
Thermal Specifications
Parameter
Operating Case Temperature
Thermal Resistance, Rth
(1)
Junction Temperature, Tj
(2)
M T vs. G DL T p re
TF
N ead em eratu
1000
-40 to +85
°C
216
°C
/ W
149
°C
MTTF (million hrs)
Rating
100
10
1. The thermal resistance is referenced from the hottest
part of the junction to the ground lead (pin 2 or 4).
2. This corresponds to the typical biasing condition of
+4.91V, 60 mA at an 85
°C
case temperature. A
minimum MTTF of 1 million hours is achieved for
junction temperatures below 177
°C.
1
60
70
80
90
100
110
120
G u dL T p re(°C
ro n ead em eratu
)
Specifications and information are subject to change without notice
WJ Communications, Inc
•
Phone 1-800-WJ1-4401
•
FAX: 408-577-6621
•
e-mail: sales@wj.com
•
Web site: www.wj.com
Page 5 of 5 September 2006
WJCI [ WJ COMMUNICATION. INC. ]
