ML501
Product Features
•
High dynamic range mixer with
integrated LO driver
•
+30 dBm Input IP3
•
8 dB Conversion Loss
•
RF: 1900 – 2700 MHz
•
LO: 1600 – 2500 MHz
•
IF: 50 – 500 MHz
•
0 dBm Drive Level
•
RoHS-compliant SOIC-8 pkg
The Communications Edge
TM
Product Information
1.9–2.7 GHz High IP3 Mixer with Integrated LO Amp
Product Description
The ML501 high linearity upconverter or downconverter
combines a passive GaAs MESFET mixer with an
integrated HBT LO driver in a low-cost lead-
free/green/RoHS-compliant SOIC-8 package.
WJ’s
ML501 uses patented techniques to realize +30 dBm Input
IP3 with 8 dB conversion loss using an LO drive level of 0
dBm in a downconverting application. The on-chip
diplexer in the mixers allows for good matching on the RF
and IF ports. The dual-stage LO driver provides a stable
input power level into the mixer to allow for consistent
performance over a wide range of LO power levels.
Typical applications include frequency up/down
conversion, modulation and demodulation for receivers and
transmitters used in 2.5G and 3G GSM/CDMA/WCDMA
systems in the PCS, or UMTS frequency bands. They can
also be used for WiBro/WiLAN/WiMAX infrastructure
requiring high linearity frequency conversion.
Functional Diagram
LO
1
8
RF
7
GND
6
GND
5
IF
The backside paddle is Ground.
GND
2
Vcc1
3
Vcc2
4
Applications
•
2.5/3G GSM/CDMA/WCDMA
•
PCS/UMTS-band Mobile
Infrastructure
•
WiBro / WiLAN / WiMAX
Specifications
(1)
Parameter
RF Frequency Range
LO Frequency Range
IF Frequency Range
SSB Conversion Loss
Input IP3
(2)
Input P1dB
LO – RF Isolation
(3)
LO – IF Isolation
(3)
RF – IF Isolation
Return Loss: RF Port
Return Loss: IF Port
Return Loss: LO Port
LO Drive Level
Supply Voltage
Operating Current
(4)
1.
2.
3.
4.
Units
MHz
MHz
MHz
dB
dBm
dBm
dB
dB
dB
dB
dB
dB
dBm
V
mA
Min
Typ
1900 – 2200
1600 – 2150
50 – 300
8
+30
+21
9
27
20
16
20
15
0
+5
110
Max
Min
Typ
2200 – 2400
1900 – 2350
50 – 300
8.1
+30
+20
8
27
21
17
20
12
0
+5
120
Max
Min
Typ
2400 – 2700
1900 – 2500
200 – 500
8.4
+28
+20
7
25
21
17
20
11
0
+5
130
Max
9
+28
-2.5
85
2.5
135
-2.5
2.5
-2.5
2.5
Min / max limits are tested for the mixer in downconverting application with a low-side LO at 0 dBm at 25 °C with RF/IF = 1900/50, 2200/50, and 1900/300 MHz.
IIP3 is measured with
Δf
= 1 MHz with RFin = 0 dBm / tone.
LO is injected with 0 dBm.
This refers to the operating current under LO drive. The current can be reduced by increasing the value of the R2 resistor slightly.
Absolute Maximum Rating
Parameter
Operating Case Temperature
Storage Temperature
DC Voltage
LO Power
Input IF / RF Power
-40 to +85
°C
-55 to +150 °C
+5.5 V
+10 dBm
+20 dBm
Rating
Ordering Information
Part No.
ML501-G
ML501-PCB
Description
1.9–2.7 GHz High IP3 Mixer w/ Integrated LO Amp
(lead-free/green/RoHS-compliant SOIC-8 package)
Full Assembled Evaluation Board
Specifications and information are subject to change without notice
Operation of this device above any of these parameters may cause permanent damage.
WJ Communications, Inc
•
Phone 1-800-WJ1-4401
•
FAX: 408-577-6621
•
e-mail: sales@wj.com
•
Web site: www.wj.com
Page 1 of 4 June 2006
WJCI [ WJ COMMUNICATION. INC. ]
