WM8772
TERMINOLOGY
1.
2.
Production Data
Signal-to-noise ratio (dB) - SNR is a measure of the difference in level between the full scale output and the output
with no signal applied. (No Auto-zero or Automute function is employed in achieving these results).
Dynamic range (dB) - DNR is a measure of the difference between the highest and lowest portions of a signal.
Normally a THD+N measurement at 60dB below full scale. The measured signal is then corrected by adding the 60dB
to it. (e.g. THD+N @ -60dB= -32dB, DR= 92dB).
THD+N (dB) - THD+N is a ratio, of the rms values, of (Noise + Distortion)/Signal.
Stop band attenuation (dB) - Is the degree to which the frequency spectrum is attenuated (outside audio band).
Channel Separation (dB) - Also known as Cross-Talk. This is a measure of the amount one channel is isolated from
the other. Normally measured by sending a full scale signal down one channel and measuring the other.
Pass-Band Ripple - Any variation of the frequency response in the pass-band region.
3.
4.
5.
6.
w
PD Rev 4.2 October 2005
12
WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
