Z8 Encore! XP
®
4K Series
Product Specification
24
VCC = 3.3V
V
POR
V
VBO
Program
Execution
Voltage
Brownout
Program
Execution
VCC = 3.3V
System Clock
Internal RESET
signal
Note: Not to Scale
POR
counter delay
Figure 6.Voltage Brown-Out Reset Operation
The POR level is greater than the VBO level by the specified hysteresis value. This
ensures that the device undergoes a Power-On Reset after recovering from a VBO condi-
tion.
Watch-Dog Timer Reset
If the device is in NORMAL or STOP mode, the Watch-Dog Timer can initiate a System
Reset at time-out if the WDT_RES Flash Option Bit is programmed to 1. This is the
unprogrammed state of the WDT_RES Flash Option Bit. If the bit is programmed to 0, it
configures the Watch-Dog Timer to cause an interrupt, not a System Reset, at time-out.
The WDT bit in the Reset Status (RSTSTAT) register is set to signify that the reset was
initiated by the Watch-Dog Timer.
External Reset Input
The RESET pin has a Schmitt-triggered input and an internal pull-up resistor. Once the
RESET pin is asserted for a minimum of four system clock cycles, the device progresses
through the System Reset sequence. Because of the possible asynchronicity of the system
clock and reset signals, the required reset duration may be as short as three clock periods
PS022815-0206
Reset, STOP Mode Recovery and Low Voltage Detection
ZILOG [ ZILOG, INC. ]
