Linux dmesg Uncompressing Linux................................................................. done, booting the kernel. Linux version 2.6.12-rc4 (root@flavio.dyndns.org) (gcc version 3.4.3) #14 Wed Aug 24 12:58:34 BRT 2005 CPU: ARM920Tid(wb) [41129200] revision 0 (ARMv4T) CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets Machine: ATMEL AT91RM9200 Memory policy: ECC disabled, Data cache writeback Built 1 zonelists Kernel command line: mem=32M console=ttyS0,115200 root=/dev/scsi/host0/bus0/target0/lun0/part1 rw AT91: 128 gpio irqs in 4 banks PID hash table entries: 256 (order: 8, 4096 bytes) Console: colour dummy device 80x30 Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 32MB = 32MB total Memory: 30336KB available (1667K code, 292K data, 72K init) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 SCSI subsystem initialized usbcore: registered new driver usbfs usbcore: registered new driver hub NetWinder Floating Point Emulator V0.97 (double precision) devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 AT91 Real Time Clock driver. AT91 SPI driver loaded AT91 Watchdog Timer enabled (5 seconds) ttyS0 at MMIO 0xfefff200 (irq = 1) is a AT91_SERIAL ttyS1 at MMIO 0xfefc4000 (irq = 7) is a AT91_SERIAL io scheduler noop registered io scheduler anticipatory registered at91_ether: Your bootloader did not configure a MAC address. eth0: AT91 ethernet at 0xfefbc000 int=24 10-HalfDuplex (00:00:00:00:00:00) eth0: Intel LXT971A PHY at91rm9200-ohci at91rm9200-ohci: AT91RM9200 OHCI at91rm9200-ohci at91rm9200-ohci: new USB bus registered, assigned bus number 1 at91rm9200-ohci at91rm9200-ohci: irq 23, io base 0x00300000 usb usb1: Product: AT91RM9200 OHCI usb usb1: Manufacturer: Linux 2.6.12-rc4 ohci_hcd usb usb1: SerialNumber: at91rm9200 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected Initializing USB Mass Storage driver... usb 1-1: new full speed USB device using at91rm9200-ohci and address 2 usb 1-1: Product: Cruzer Micro usb 1-1: Manufacturer: SanDisk Corporation usb 1-1: SerialNumber: SNDK2199950D57608305 scsi0 : SCSI emulation for USB Mass Storage devices usbcore: registered new driver usb-storage USB Mass Storage support registered. mice: PS/2 mouse device common for all mice i2c /dev entries driver Found AT91 i2c NET: Registered protocol family 2 IP: routing cache hash table of 512 buckets, 4Kbytes TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) NET: Registered protocol family 1 NET: Registered protocol family 17 Vendor: SanDiskModel: Cruzer MicroRev: 0.2 Type:Direct-AccessANSI SCSI revision: 02 SCSI device sda: 1000944 512-byte hdwr sectors (512 MB) sda: Write Protect is off sda: assuming drive cache: write through SCSI device sda: 1000944 512-byte hdwr sectors (512 MB) sda: Write Protect is off sda: assuming drive cache: write through /dev/scsi/host0/bus0/target0/lun0: p1 Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 ReiserFS: sda1: found reiserfs format "3.6" with standard journal ReiserFS: sda1: using ordered data mode ReiserFS: sda1: journal params: device sda1, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: sda1: checking transaction log (sda1) ReiserFS: sda1: Using r5 hash to sort names VFS: Mounted root (reiserfs filesystem). Mounted devfs on /dev Freeing init memory: 72K INIT: version 2.86 booting Activating swap. Checking root file system... fsck 1.37 (21-Mar-2005) Reiserfs super block in block 16 on 0x801 of format 3.6 with standard journal Blocks (total/free): 125104/74850 by 4096 bytes Filesystem is clean Filesystem seems mounted read-only. Skipping journal replay. Checking internal tree..finished System time was Thu Jan1 00:00:29 UTC 1998. Setting the System Clock using the Hardware Clock as reference... System Clock set. System local time is now Thu Jan1 00:00:30 UTC 1998. Cleaning up ifupdown...done. Checking all file systems... fsck 1.37 (21-Mar-2005) Setting kernel variables ... ... done. Mounting local filesystems... Cleaning /tmp /var/run /var/lock. Setting up networking...done. Setting up IP spoofing protection: rp_filter. Configuring network interfaces...eth0: Setting MAC address to aa:bb:cc:00:11:22 eth0: Link down. eth0: Link down. done. Setting the System Clock using the Hardware Clock as reference... System Clock set. Local time: Wed Dec 31 22:00:35 BRST 1997 Initializing random number generator...done. INIT: Entering runlevel: 2 Starting internet superserver: inetd. Starting OpenBSD Secure Shell server: sshd. Debian GNU/Linux 3.1 (none) ttyS0 (none) login:
作者：wenming 2005-11-11 15:56:00 |
