Rev PrA, 13-Aug-07
ACT4075
PACKING
TUBE
TAPE & REEL
ORDERING INFORMATION
PART NUMBER
ACT4075YH
ACT4075YH-T
TEMPERATURE RANGE
-40°C to 85°C
-40°C to 85°C
PACKAGE
SOP-8/EP
SOP-8/EP
PINS
8
8
PIN CONFIGURATION
BS
IN
SW
G
1
2
8
7
N/C
EN
COMP
FB
ACT4075
3
4
EP
SOP-8/EP
6
5
PIN DESCRIPTIONS
PIN NUMBER
1
2
3
4
5
6
PIN NAME
BS
IN
SW
G
FB
COMP
PIN DESCRIPTION
Bootstrap. This pin acts as the positive rail for the high-side switch’s gate driver.
Connect a 10nF between this pin and SW.
Input Supply. Bypass this pin to G with a low ESR capacitor. See
Input Capacitor
in
Application Information
section.
Switch Output. Connect this pin to the switching end of the inductor.
Ground.
Feedback Input. The voltage at this pin is regulated to 1.222V. Connect to the
resistor divider between output and ground to set output voltage.
Compensation Pin. See
Compensation Technique
in
Application Information
sec-
tion.
Enable Input. When higher than 1.3V, this pin turns the IC on. When lower than
0.7V, this pin turns the IC off. Output voltage is discharged when the IC is off. This
pin has a small internal pull up current to a high level voltage when pin is not con-
nected.
Not Connected.
Exposed Pad shown as dashed box. The exposed thermal pad should be con-
nected to board ground plane and pin 4. The ground plane should include a large
exposed copper pad under the package for thermal dissipation (see package out-
line). The leads and exposed pad should be flush with the board, without offset
from the board surface.
7
8
EN
N/C
EP
EP
Innovative Products.
Active Solutions.
-2-
Copyright © 2007 Active-Semi, Inc.