AAT3140
High Efficiency 1X/1.5X/2X Charge Pump
for White LED Applications
General Description
The AAT3140 is a low noise, constant frequency
charge pump DC/DC converter that uses a tri-mode
load switch (1X), fractional (1.5X), and doubling (2X)
conversion to maximize efficiency for white LED appli-
cations. The device produces current levels up to
30mA on each of its four current source outputs to
drive various arrangements of LEDs from a 2.7V to
5.5V input. Outputs may be operated individually or in
parallel for driving higher-current LEDs. A low external
parts count (two 1µF flying capacitors and two small
1µF capacitors at V
IN
and CP) make the AAT3140 ide-
ally suited for small battery-powered applications.
The AAT3140 is equipped with AnalogicTech’s unique
AutoBias™ technology which allows individual LEDs
to be powered either by charge pump or battery input,
determined internally and automatically to maximize
the power efficiency even with a large difference in
LED forward voltage.
AnalogicTech's Simple Serial Control™ (S
2
Cwire™)
digital input is used to enable, disable, and set the
LED drive current with a 32-level logarithmic scale
LED brightness control. The AAT3140 has a thermal
management system to protect the device in the event
of a short-circuit condition at an output pin. Built-in soft-
start circuitry prevents excessive inrush current during
start-up. A high charge pump switching frequency
enables the use of very small external capacitors. In
shutdown mode, the device disconnects the load from
V
IN
and reduces quiescent current to less than 1µA.
The AAT3140 is available in the very small, Pb-free
12-pin TSOPJW package.
Features
•
•
•
•
•
•
•
•
•
•
•
•
•
•
ChargePump
™
V
IN
Range: 2.7V to 5.5V
Tri-Mode 1X, 1.5X, and 2X Charge Pump for
Maximum Efficiency and V
F
Coverage
Drives Low-V
F
and High-V
F
Type LEDs
Up to Four 30mA Outputs
32-Position Logarithmic Scale with Digital
Control
Low Noise Constant Frequency Operation
1MHz Switching Frequency
AutoBias Technology
Small Application Circuit
Regulated Output Current
Automatic Soft Start
No Inductors
I
Q
< 1µA in Shutdown
12-Pin TSOPJW Package
Applications
•
•
•
•
Color (RGB) Lighting
Programmable Current Sources
White LED Backlighting
White Photo Flash for Digital Still Cameras
Typical Application
VIN
C1+
C1
1μF
CP
V
BATTERY
C
IN
1μF
C
CP
1μF
C1-
C2+
C2
1μF
AAT3140
C2-
D1
D2
D3
D4
EN/SET
EN/SET
D4
GND
D3
D2
D1
3140.2007.03.1.3
1
ANALOGICTECH [ ADVANCED ANALOGIC TECHNOLOGIES ]
