XC0450A-03P 参数 Datasheet PDF下载

Model XC2100A-20

Rev D

Notes on RF Testing and Circuit Layout

The XC2100A-20 Surface Mount Couplers require the use of a test fixture for verification of RF performance. This test

fixture is designed to evaluate the coupler in the same environment that is recommended for installation. Enclosed

inside the test fixture, is a circuit board that is fabricated using the recommended footprint. The part being tested is

placed into the test fixture and pressure is applied to the top of the device using a pneumatic piston. A four port Vector

Network Analyzer is connected to the fixture and is used to measure the S-parameters of the part. Worst case values

for each parameter are found and compared to the specification. These worst case values are reported to the test

equipment operator along with a Pass or Fail flag. See the illustrations below.

3 & 5 dB

Test Board

10 & 20 dB

Test Board

Test Board

In Fixture

Test Station

Available on Tape

and Reel for Pick and

Place Manufacturing.

USA/Canada:

Toll Free:

Europe

:

(315) 432-8909

(800) 411-6596

+44 2392-232392