HCPL-2200, HCPL-2219
Low Input Current Logic Gate Optocouplers
Data Sheet
Description
The HCPL-2200/2219 are optically coupled logic gates
that combine a GaAsP LED and an integrated high gain
photo detector. The detector has a three state output
stage and has a detector threshold with hysteresis. The
three state output eliminates the need for a pullup
resistor and allows for direct drive of data busses. The
hysteresis provides differential mode noise immunity
and eliminates the potential for output signal chatter.
A superior internal shield on the HCPL-2219 guarantees
common mode transient immunity of 2.5 kV/µs at a
common mode voltage of 400 volts.
The Electrical and Switching Characteristics of the
HCPL-2200/2219 are guaranteed over the tempera-
ture range of 0° C to 85° C and a V
CC
range of 4.5 volts to
20 volts. Low I
F
and wide V
CC
range allow compatibility
with TTL, LSTTL, and CMOS logic and result in lower
power consumption compared to other high speed
optocouplers. Logic signals are transmitted with a
typical propagation delay of 160 nsec.
The HCPL-2200/2219 are useful for isolating high
speed logic interfaces, buffering of input and output
lines, and implementing isolated line receivers in
high noise environments.
Features
• 2.5 kV/µs minimum Common Mode Rejection (CMR) at
V
CM
= 400 V (HCPL-2219)
• Compatible with LSTTL, TTL, and CMOS logic
• Wide V
CC
range (4.5 to 20 V)
• 2.5 Mbd guaranteed over temperature
• Low input current (1.6 mA)
• Three state output (no pullup resistor required)
• Guaranteed performance from 0°C to 85°C
• Hysteresis
• Safety approval
– UL recognized -3750 V rms for 1 minute
– CSA approved
– IEC/EN/DIN EN 60747-5-2 approved with
V
IORM
= 630 V
peak
(HCPL-2219 Option 060 only)
• MIL-PRF-38534 hermetic version available
(HCPL-5200/1)
Applications
• Isolation of high speed logic systems
• Computer-peripheral interfaces
• Microprocessor system interfaces
• Ground loop elimination
• Pulse transformer replacement
• Isolated buss driver
• High speed line receiver
Functional Diagram
NC 1
ANODE 2
CATHODE 3
NC 4
8 V
CC
7 V
O
6 V
E
5 GND
TRUTH TABLE
(POSITIVE LOGIC)
LED
ENABLE OUTPUT
ON
H
Z
OFF
Z
H
ON
H
L
OFF
L
L
SHIELD
A 0.1
µF
bypass capacitor must be connected between pins 5 and 8.
CAUTION: It is advised that normal static precautions be taken in handling and assembly of this
component to prevent damage and/or degradation which may be induced by ESD.
AVAGO [ AVAGO TECHNOLOGIES LIMITED ]
