HCPL-2400, HCPL-2430
20 MBd High CMR Logic Gate Optocouplers
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The HCPL-2400 and HCPL-2430 high speed opto-cou-
plers combine an 820 nm AlGaAs light emitting diode
with a high speed photodetector. This combina-tion re-
sults in very high data rate capability and low input cur-
rent. The totem pole output (HCPL-2430) or three state
output (HCPL-2400) eliminates the need for a pull up re-
sistor and allows for direct drive of data buses.
The detector has optical receiver input stage with built-
in Schmitt trigger to provide logic compatible wave-
forms, eliminating the need for additional waveshaping.
The hysteresis provides differential mode noise immuni-
ty and minimizes the potential for output signal chatter.
The electrical and switching characteristics of the HCPL-
2400 and HCPL-2430 are guaranteed over the tempera-
ture range of 0°C to 70°C.
Functional Diagram
HCPL-2400/11
1 NC
2
3
4 NC
V
CC
8
7
6
5
ANODE 1 1
CATHODE 1 2
CATHODE 2 3
ANODE 2 4
HCPL-2430
8 V
CC
7 V
O1
6
V
O2
Features
• High speed: 40 MBd typical data rate
• High common mode rejection:
HCPL-2400: 10 kV/µs at V
CM
= 300 V (typical)
• AC performance guaranteed over temperature
• High speed AlGaAs emitter
• Compatible with TTL, STTL, LSTTL, and HCMOS logic
families
• Totem pole and tri state output (no pull up resistor
required)
• Safety approval
– UL recognized – 3750 V rms for 1 minute per
UL1577
– IEC/EN/DIN EN 60747-5-2 approved with
V
IORM
= 630 V
peak
(Option 060) for HCPL-2400
– CSA approved
• High power supply noise immunity
• MIL-PRF-38534 hermetic version available
(HCPL-5400/1 and HCPL-5430/1)
Applications
• Isolation of high speed logic systems
• Computer-peripheral interfaces
• Switching power supplies
GND
5 GND
TRUTH TABLE
(POSITIVE LOGIC)
LED
ON
OFF
ON
OFF
ENABLE
L
L
H
H
OUTPUT
L
H
Z
Z
TRUTH TABLE
(POSITIVE LOGIC)
LED
OUTPUT
ON
L
OFF
H
• Isolated bus driver (networking applications)
• Ground loop elimination
• High speed disk drive I/O
• Digital isolation for A/D, D/A conversion
• Pulse transformer replacement
A 0.1 µF bypass capacitor must be connected between pins 5 and 8.
HCPL-2400 Functional Diagram
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.
AVAGO [ AVAGO TECHNOLOGIES LIMITED ]
