epc110
Absolute Maximum Ratings
(Notes 1, 2)
Voltage at any pin except pin VDD
Power Supply Voltage at pin VDD
Programming Voltage at pin VDD
Power Supply Voltage at pin VDD33
Output current at any pin except pin LED
Power Consumption with maximum load
Lead Temperature solder, 4 sec. (T
L
)
-0.3V to V
N
+0.3 V
-0.3V to +5.5V
-0.3V to +8.0V
-0.3V to +5.5V
-6mA to +6mA
125 mW
+260°C
Humidity (non-condensing)
+5
+95
%
Operating supply voltage at VDD
Programming voltage at VDD
Operating supply voltage at VDD33
Operating Temperature (T
O
)
Recommended Operating Conditions
Min.
3.0
7.0
3.0
-40°
Max.
3.6
8.0
3.6
+85°
Units
V
V
V
C
Note 1:
Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Recommended operating conditions
indicate conditions for which the device is intended to be functional, but do not guarantee specific performance limits. For guaranteed specific -
ations and test conditions, see Electrical Characteristics.
Note 2:
This device is a highly sensitive CMOS ac current amplifier with an ESD rating of JEDEC HBM class 0 (<250V). Handling and
assembly of this device should only be done at ESD protected workstations.
Electrical Characteristics
3.0V < V
N
< 3.6V, -40°C < T
A
< +85°C, unless otherwise specified
General Data
Symbol
V
N
V
PUP
V
PP
Parameter
Operating power supply voltage
Power-up Threshold Voltage
Ripple on supply voltage,
peak to peak
Conditions/Comments
Min.
at VDD33 (and VDD)
Voltage at VDD33 when the device starts up
Input pulse I
PD NST
36nA
48nA
72nA
108nA
I
N
I
Prog
V
OH
V
OL
V
HOH
V
LEDH
I
LED
V
IH
V
IL
I
LEAKD
R
PU
f
clk
df
clk
Current consumption operating
Current consumption programming
Output high voltage
Output low voltage
Output high voltage OUTH
Output high voltage LED
Source current maximum
Input high voltage
Input low voltage
Input leakage current
Pull-up resistor
Reference clock
Temperature drift
internal at digital input
of internal oscillator - for information only
All internal timings are referenced to this clock
of the oscillator - for information only
30
32
640
in operation mode, I
PD
= 0 mA, no load
in program mode, VDD @ 8.0V, I
PD
= 0 mA, no load
except OUTH and LED
@ 4mA source, including OUTH and LED
see Figure 8
@ 0.1mA sink current
at Pin LED, V
LED
@ 0... V
N
- 1.0V
V
N
- 0.5V
0.7
0.7*V
N
GND
1.3
V
N
0.3*V
N
10
200
V
mA
V
V
µA
kΩ
MHz
ppm/K
V
N
- 0.5V
0.5
70
150
350
600
2
4
mV
mV
mV
mV
mA
mA
V
V
3
2.4
Values
Typ.
Max.
3.6
3
V
Units
© 2011 ESPROS Photonics Corporation
Characteristics subject to change without notice
2
Datasheet epc110 - V2.1
www.espros.ch
EPC [ ESPROS PHOTONICS CORP ]
