Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
4.2
Testing the board.
Ensure that the Power Select jumper JP6 is in „P.S.‟ position (pins 2 & 3 shorted), to enable the board to
be powered from the external power adapter.
Connect the 5V DC/1A power supply included in V2-Eval Kit to the external input power adapter
connector (CN12), connect USB A/B cable to USB B connector (CN13) on V2-Eval Board and to a free
USB port on host PC. Switch SW1 to the ON position (towards board edge). LED2 – POWER should now
be on.
Figure 4.2
Power connector with Jumper JP6
The PCB circuitry will draw power either directly from the board 5V supply or from a 3.3V regulator that is
powered by this 5V supply. This includes the VNC2 daughterboard module that is installed on the board.
Upon power up, the power LED (LED2) will illuminate.
Copyright © 2010 Future Technology Devices International Limited
12
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
