X24320
Temperature under Bias
.......................................–65°C to +135°C
X24320
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device. This
is a stress rating only and the functional operation
Storage Temperature........................–65°C to +150°C
Voltage on any Pin with
Respect to VSS .................................... –1V to +7V
D.C. Output Current ..............................................5mA
Lead Temperature (Soldering,
of the device at these or any other conditions above
those indicated in the operational sections of this
specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect device reliability.
..............................300°C
10 seconds)
RECOMMENDED OPERATING CONDITIONS
Supply Voltage
X24320
Limits
Temperature
Commercial
Industrial
Min.
0°C
Max.
+70°C
+85°C
4.5V to 5.5V
2.5V to 5.5V
1.8V to 3.6V
X24320–2.
5
–40°C
X24320–1.
8
7003 FRM T04
7003 FRM T05
D.C. OPERATING CHARACTERISTICS
Limits
Symbol
Parameter
Min.
Max.
Units
mA
Test Conditions
ICC1
VCC Supply Current (Read)
1
3
SCL = VCC X 0.1/VCC X 0.9 Levels @
400KHz, SDA = Open, All Other
Inputs = VSS or VCC – 0.3V
ICC2
VCC Supply Current (Write)
VCC Standby Current
mA
∝A
∝A
(1)
5
SCL = SDA = VCC, All Other
Inputs = VSS or VCC – 0.3V,
VCC = 5V 10%
ISB1
(1)
VCC Standby Current
SCL = SDA = VCC, All Other
Inputs = VSS or VCC – 0.3V,
VCC = 2.5V
1
ISB2
∝A
∝A
ILI
VIN = VSS to VCC
VOUT = VSS to VCC
Input Leakage Current
Output Leakage Current
Input LOW Voltage
10
10
ILO
(2)
VCC x 0.3
VCC + 0.5
0.4
–0.5
V
V
VlL
(2)
Input HIGH Voltage
Output LOW Voltage
VCC x 0.7
VIH
VOL
IOL = 3mA
V
V
(3)
VCC x 0.05
Vhys
Hysteresis of Schmitt
Trigger Inputs
7003 FRM T06
CAPACITANCE TA = +25°C, f = 1MHz, VCC = 5V
Symbol
Parameter
Max.
Units
Test Conditions
(3)
VI/O = 0V
VIN = 0V
Input/Output Capacitance (SDA)
8
6
pF
CI/O
(3)
Input Capacitance (S0, S1, S2, SCL, WP)
pF
CIN
7003 FRM T07
Notes: (1)Must perform a stop command prior to measurement.
(2)VIL min. and VIH max. are for reference only and are not 100% tested. (3)This
parameter is periodically sampled and not 100% tested.
11
ICMIC [ IC MICROSYSTEMS ]
