HIN202A thru HIN241A
Pin Descriptions
PIN
FUNCTION
V
Power Supply Input 5V ±10%, (5V ±5% HIN207A).
CC
V+
V-
Internally generated positive supply (+10V nominal).
Internally generated negative supply (-10V nominal).
Ground Lead. Connect to 0V.
GND
C1+
C1-
C2+
C2-
External capacitor (+ terminal) is connected to this lead.
External capacitor (- terminal) is connected to this lead.
External capacitor (+ terminal) is connected to this lead.
External capacitor (- terminal) is connected to this lead.
Transmitter Inputs. These leads accept TTL/CMOS levels. An internal 400kΩ pull-up resistor to V
Transmitter Outputs. These are RS-232 levels (nominally ±10V).
T
is connected to each lead.
CC
IN
T
OUT
R
Receiver Inputs. These inputs accept RS-232 input levels. An internal 5kΩ pull-down resistor to GND is connected to each input.
IN
R
Receiver Outputs. These are TTL/CMOS levels.
OUT
EN
SD, SD
NC
Enable Input. This is an active low input which enables the receiver outputs. With EN = 5V, the outputs are placed in a high
impedance state.
Shutdown Input. With SD = 5V (HIN213A SD = 0V), the charge pump is disabled, the receiver outputs are in a high impedance
state (except R4 and R5 of HIN241A) and the transmitters are shut off.
No Connect. No connections are made to these leads.
3-10
INTERSIL [ Intersil ]
