®
X5323, X5325
(Replaces X25323, X25325)
Data Sheet
October 27, 2005
FN8131.1
CPU Supervisor with 32Kb SPI EEPROM
FEATURES
• Selectable watchdog timer
• Low V
CC
detection and reset assertion
—Five standard reset threshold voltages
—Re-program low V
CC
reset threshold voltage
using special programming sequence
—Reset signal valid to V
CC
= 1V
• Determine watchdog or low voltage reset with a
volatile flag bit
• Long battery life with low power consumption
—<50µA max standby current, watchdog on
—<1µA max standby current, watchdog off
—<400µA max active current during read
• 32Kbits of EEPROM
• Built-in inadvertent write protection
—Power-up/power-down protection circuitry
—Protect 0, 1/4, 1/2 or all of EEPROM array with
Block Lock
™
protection
—In circuit programmable ROM mode
• 2MHz SPI interface modes (0,0 & 1,1)
• Minimize EEPROM programming time
—32-byte page write mode
—Self-timed write cycle
—5ms write cycle time (typical)
• 2.7V to 5.5V and 4.5V to 5.5V power supply
operation
• Available packages
—14 Ld TSSOP, 8 Ld SOIC, 8 Ld PDIP
• Pb-free plus anneal available (RoHS compliant)
BLOCK DIAGRAM
Watchdog Transition
Detector
WP
SI
SO
SCK
CS/WDI
Data
Register
Command
Decode &
Control
Logic
V
CC
Threshold
Reset Logic
Protect Logic
DESCRIPTION
These devices combine four popular functions, Power-on
Reset Control, Watchdog Timer, Supply Voltage
Supervision, and Block Lock Protect Serial EEPROM
Memory in one package. This combination lowers
system cost, reduces board space requirements, and
increases reliability.
Applying power to the device activates the power-on
reset circuit which holds RESET/RESET active for a
period of time. This allows the power supply and oscilla-
tor to stabilize before the processor can execute code.
The Watchdog Timer provides an independent protec-
tion mechanism for microcontrollers. When the micro-
controller fails to restart a timer within a selectable
time out interval, the device activates the
RESET/RESET signal. The user selects the interval
from three preset values. Once selected, the interval
does not change, even after cycling the power.
The device’s low V
CC
detection circuitry protects the
user’s system from low voltage conditions, resetting the
system when V
CC
falls below the minimum V
CC
trip
point. RESET/RESET is asserted until V
CC
returns to
proper operating level and stabilizes. Five industry stan-
dard V
TRIP
thresholds are available, however, Intersil’s
unique circuits allow the threshold to be reprogrammed
to meet custom requirements or to fine-tune the thresh-
old for applications requiring higher precision.
Watchdog
Timer Reset
RESET/RESET
Status
Register
8Kbits
8Kbits
16Kbits
EEPROM Array
Reset &
Watchdog
Timebase
X5323 = RESET
X5325 = RESET
V
CC
V
TRIP
+
-
Power-on and
Low Voltage
Reset
Generation
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774
|
Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
INTERSIL [ INTERSIL CORPORATION ]
