E3F2
E3F2
Precautions
If the input/output lines of the Photoelectric Sensor are placed in
the same conduit or duct as power lines or high-voltage lines, the
Photoelectric Sensor could be induced to malfunction, or even be
damaged, by electrical noise. Separate the wiring, or use
When using the Photoelectric Sensor at temperatures over 45°C,
the load current must be within the rated value shown in the
figure below.
shielded lines as input/output lines to the Photoelectric Sensor.
200
Do not subject the Photoelectric Sensor to excessive shock when
mounting, in keeping with IEC60529 IP66 standards.
130
Do not connect the black wire to the brown wire without a load.
Direct connection of these wires may damage the Photoelectric
Sensor (AC switching type).
Brown
0
Load
45
55
Operating temperature (°C)
Sensor
24 to 240 VAC
Black
Blue
J MOUNTING
Do not exceed a torque of
!
•
•
2.0 NS m {20 kgf S cm} 17.7 in S lb when tightening mounting nuts
for plastic models.
WARNING
The E3F2 Photoelectric Sensor is not a safety component for
ensuring the safety of people which is defined in EC Directive
(91/368/EEC) and covered by separate European standards
or by any other regulations or standards.
20.0 N S m {200 kgf S cm} 177 in S lb when tightening mounting
nuts for metal models.
When using the Photoelectric Sensor in the vicinity of an inverter
motor, be sure to connect the ground wire of the motor to earth.
Failure to ground the motor may result in malfunction of the
Sensor.
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
R
OMRON ELECTRONICS, INC.
One East Commerce Drive
Schaumburg, IL 60173
OMRON CANADA, INC.
885 Milner Avenue
Scarborough, Ontario M1B 5V8
1-800-55-OMRON
416-286-6465
Cat. No. CEDSAX3
10/99
Specifications subject to change without notice.
Printed in U.S.A.
OMRON [ OMRON ELECTRONICS LLC ]
