CUSTOMER DRAWING
TABLE 1
REQUIREMENTS FOR MOLDED COMPONENT
Property
Tensile Strength
Ultimate Elongation
Stiffness
Specific Gravity
Hardness
Low Temperature Flexibility
4 hours @ -55°C (-67°F)
Heat Shock
4 hours @ 225°C (437°F)
Heat Aging
Followed by test for:
Tensile Strength
Ultimate Elongation
Flammability
Fungus Resistance
Water Absorption
24 hours @ 25° C (77°F)
Solvent Resistance
24 hours @ 25°C (77°F) in
JP-4 Fuel
Skydrol* 500
Hydraulic Fluid (MIL-H-5606)
Aviation Gasoline (100/130)
Water
Followed by test for:
Tensile Strength
Ultimate Elongation
Unit
psi
percent
psi
Requirement
1500 minimum
250 minimum
10,000 minimum
25,000 maximum
1.40 maximum
50±10
No cracking
No Dripping, flowing or
cracking
Method of Test
Section 4.3.1
(ASTM D 412)
ASTM D 747
ASTM D 792
ASTM D 2240
Section 4.3.2
Section 4.3.3
Section 4.3.4
Procedures A and B
psi
percent
1200 minimum
200 minimum
Non-burning
Rating of 1 or less
0.2 maximum
Section 4.3.1
(ASTM D 412)
ASTM D 635
ASTM D 876
ASTM D 570
Procedure A
Section 4.3.5
Shore D
percent
psi
percent
1200 minimum
200 minimum
Section 4.3.1
(ASTM D 412)
Tyco Electronics
305 Constitution Dr
Menlo Park, CA
94025, U.S.A.
TITLE:
CAP, SPLICE ENCAPSULATION
DOCUMENT NO.:
Unless otherwise specified dimensions are in millimeters.
[Inches dimensions are shown in brackets]
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
DRAWN BY:
ANGLES: N/A
ROUGHNESS
IN MICRON
CAGE CODE:
Raychem
Devices
D-300-08/-12/-18
REV:
DATE:
Tyco Electronics reserves the right to
amend this drawing at any time. Users
should evaluate the suitability of the
product for their application.
ECO NUMBER:
REPLACES:
B
SCALE:
SIZE:
31-July-08
SHEET:
M. FORONDA
06090
D010044
08-018889
NTS
A
5 of 7
© 2008 Tyco Electronics Corporation. All rights reserved
If this document is printed it becomes uncontrolled. Check for the latest revision.
PANDUIT [ PANDUIT CORP. ]
