Model 4233 & 5524 with Assembly Instructions
Do-It-Yourself Micrograbber®
& Test Clip Kits
Pomona®
FIGURE #1
A. Remove the cap from housing assembly, the
contact will now be exposed.
B. Insert the wire into the cap assembly allowing
approximately 1 to 2 inches of wire to extend
beyond the cap.
C. Strip wire 1/8 to 3/16 inches.
D. Insert exposed conductor through the hole in the
contact and solder to surface.
FIGURE #2
E. Important: Solder must not extend beyond the
indicated width.
FIGURE #3
F. Install the cap onto the housing assembly. Align
the contact with the slots located on the cap.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies. Made in USA
6/9/99
PomonaACCESS 90592 (800) 444-6785 or (425) 446-6010
Sales: 800-490-2361 Fax: 888-403-3360
Technical Assistance: 800-241-2060
SY/EH/LS
More drawings available at www.pomonaelectronics.com
S:\Engineering\Release\DataSheets\FlukeDataSheet\d_AI_4233_5524_2_01.doc
Page 2 of 2