November 2006
rev 0.2
Capacitance
1,2
(T
A
= +25°C, F = 1.0MHz)
Symbol
C
IN
ASM2P5T905A
Parameter
Input Capacitance
Min
Typ
3.5
Max
Unit
pF
Notes:
1. This parameter is measured at characterization but not tested.
2. Capacitance applies to all inputs except RxS and TxS.
Recommended Operating Range
Symbol
T
A
V
DD1
V
DDQ1
Description
Ambient Operating Temperature
Internal Power Supply Voltage
HSTL Output Power Supply Voltage
Extended HSTL and 1.8V LVTTL Output Power
Supply Voltage
2.5V LVTTL Output Power Supply Voltage
Termination Voltage
Min
-40
2.4
1.4
1.65
Typ
+25
2.5
1.5
1.8
V
DD
V
DDQ
/ 2
Max
+85
2.6
1.6
1.95
Unit
°C
V
V
V
V
V
V
T
NOTE:
1. All power supplies should operate in tandem. If V
DD
or V
DDQ
is at maximum, then V
DDQ
or V
DD
(respectively) should be at maximum, and vice-versa.
Input/Output Selection
1
Input
2.5V LVTTL SE
1.8V LVTTL SE
2.5V LVTTL DSE
1.8V LVTTL DSE
LVEPECL DSE
eHSTL DSE
HSTL DSE
2.5V LVTTL DIF
1.8V LVTTL DIF
LVEPECL DIF
eHSTL DIF
HSTL DIF
2.5V LVTTL SE
1.8V LVTTL SE
2.5V LVTTL DSE
1.8V LVTTL DSE
LVEPECL DSE
eHSTL DSE
HSTL DSE
2.5V LVTTL DIF
1.8V LVTTL DIF
LVEPECL DIF
eHSTL DIF
HSTL DIF
Output
Input
2.5V LVTTL SE
1.8V LVTTL SE
2.5V LVTTL DSE
1.8V LVTTL DSE
LVEPECL DSE
eHSTL DSE
HSTL DSE
2.5V LVTTL DIF
1.8V LVTTL DIF
LVEPECL DIF
eHSTL DIF
HSTL DIF
2.5V LVTTL SE
1.8V LVTTL SE
2.5V LVTTL DSE
1.8V LVTTL DSE
LVEPECL DSE
eHSTL DSE
HSTL DSE
2.5V LVTTL DIF
1.8V LVTTL DIF
LVEPECL DIF
eHSTL DIF
HSTL DIF
Output
2.5V LVTTL
eHSTL
1.8V LVTTL
HSTL
NOTE:
1. The INPUT/OUTPUT SELECTION Table describes the total possible combinations of input and output interfaces. Single-Ended (SE) inputs in a single-ended
mode require the A/V
REF
pin to be connected to GND. Differential Single-Ended (DSE) is for single-ended operation in differential mode, requiring a V
REF
.
Differential (DIF) inputs are used only in differential mode.
2.5V Single Data Rate 1:5 Clock Buffer Terabuffer
Notice: The information in this document is subject to change without notice.
4 of 19