M27C4002
Table 5. AC Measurement Conditions
High Speed
Input Rise and Fall Times
Input Pulse Voltages
Input and Output Timing Ref. Voltages
≤
10ns
0 to 3V
1.5V
Standard
≤
20ns
0.4V to 2.4V
0.8V and 2V
Figure 3A. AC Testing Input Output Waveform
Figure 4. AC Testing Load Circuit
1.3V
High Speed
3V
1.5V
0V
DEVICE
UNDER
TEST
2.0V
0.8V
AI01822
1N914
3.3kΩ
Standard
2.4V
OUT
CL
0.4V
CL = 30pF for High Speed
CL = 100pF for Standard
CL includes JIG capacitance
AI01823B
Table 6. Capacitance
(1)
(T
A
= 25 °C, f = 1 MHz)
Symbol
C
IN
C
OUT
Parameter
Input Capacitance
Output Capacitance
Test Condition
V
IN
= 0V
V
OUT
= 0V
Min
Max
6
12
Unit
pF
pF
Note: 1. Sampled only, not 100% tested.
Standby Mode
The M27C4002 has a standby mode which reduc-
es the supply current from 50mA to 100µA. The
M27C4002 is placed in the standby mode by ap-
plying a CMOS high signal to the E input. When in
the standby mode, the outputs are in a high imped-
ance state, independent of the G input.
Two Line Output Control
Because EPROMs are usually used in larger
memory arrays, the product features a 2 line con-
trol function which accommodates the use of mul-
tiple memory connection. The two line control
function allows:
a. the lowest possible memory power dissipation,
b. complete assurance that output bus contention
will not occur.
For the most efficient use of these two control
lines, E should be decoded and used as the prima-
ry device selecting function, while G should be
made a common connection to all devices in the
array and connected to the READ line from the
system control bus. This ensures that all deselect-
ed memory devices are in their low power standby
mode and that the output pins are only active
when data is required from a particular memory
device.
4/18
STMICROELECTRONICS [ STMICROELECTRONICS ]
