VND600PEP-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
TYPE
VND600PEP-E
(*) Per each channel
■
■
Figure 1. Package
I
lim
25A
V
CC
36V
R
DS(on)
30mΩ
(*)
DC SHORT CIRCUIT CURRENT: 25A
CMOS COMPATIBLE INPUTS
■
PROPORTIONAL LOAD CURRENT SENSE
■
UNDERVOLTAGE AND OVERVOLTAGE
SHUT-DOWN
■
OVERVOLTAGE CLAMP
■
THERMAL SHUT-DOWN
■
CURRENT LIMITATION
■
VERY LOW STAND-BY POWER DISSIPATION
■
PROTECTION AGAINST:
LOSS OF GROUND AND LOSS OF V
CC
■
REVERSE BATTERY PROTECTION (**)
■
IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
DESCRIPTION
The VND600PEP-E is a monolithic device made
using
STMicroelectronics
VIPower
M0-3
technology. It is intended for driving resistive or
inductive loads with one side connected to ground.
Active V
CC
pin voltage clamp protects the device
against low energy spikes (see ISO7637 transient
compatibility table).
PowerSSO-24
This device has two channels in high side
configuration; each channel has an analog sense
output on which the sensing current is proportional
(according to a known ratio) to the corresponding
load current. Built-in thermal shut-down and
outputs current limitation protect the chip from
over temperature and short circuit. Device turns off
in case of ground pin disconnection.
Table 2. Order Codes
Package
PowerSSO-24
Note: (**) See application schematic at page 9
Tube
VND600PEP-E
Tape and Reel
VND600PEPTR-E
Rev. 5
May 2005
1/19
This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice.
STMICROELECTRONICS [ STMICROELECTRONICS ]
