General Description
The new model RP12/24ADA Series Retrofit Plate allows
adding an ADA compliant visible notification appliance to
most existing 4 or 5 inch square horns or speakers. All
RP12/24ADA Series Strobe Retrofit Plates are suitable for
primary signaling in public mode life safety applications.
The Strobe Retrofit Plates can be connected to the alarm
indicating circuit of a UL listed fire alarm control panel.
They are compatible with DC line supervision. Panels may
have full-wave rectified, unfiltered power supplies. The
Strobe Retrofit Plates are available for 24VDC operation or
12VDC operation. The strobe features low current draw
with no measurable in-rush in excess of peak current. The
Strobe Retrofit Plate is intended for wall mounting only to
a 4″ square electrical backbox.
Electrical Ratings – Strobe Only
Model
RP2415ADA
RP241575ADA
RP2475ADA
RP24110ADA
RP1215ADA
RP121575ADA
Supply
Voltage Range
20–30VDC
20–30VDC
20–30VDC
20–30VDC
10.5–17VDC
10.5–17VDC
Peak Operating
Current (mA)
180
220
400
500
380
560
In-rush Current in
Excess of Peak
Operating Current (mA)
0
0
0
0
0
0
Average
Operating Current
from Regulated
Supply (mA)
75
93
170
210
170
225
Average Operating
Current from
Full Wave Rectified,
Unfiltered Supply (mArms)*
90
120
200
245
200
270
* For additional information, see installation manual D900-09-00.
Actual 12 volt operating voltage cannot be less than 8.5 VDC or greater than 18.7 VDC; actual 24 volt operating voltage cannot be less than 16 greater
than 33 VDC.
Engineering Specifications
ADA Strobe Retrofit Plate shall be a System Sensor Model
______ listed to
Standard UL 1971 for the Hearing
Impaired
and shall be approved for Fire Protective Service.
The ADA Strobe Retrofit Plate series shall retrofit most 4″
or 5″ square horn or speaker into an ADA compliant
visible notification device. Strobe Retrofit Plate shall be
wired as a Primary Signaling Notification appliance. Strobe
Retrofit Plate shall also comply with the Americans with
Disabilities Act requirements for visible signaling
appliances. Strobe Retrofit Plate shall operate on 12 or
24VDC from a regulated DC supply or full-wave rectified,
unfiltered supply. The Strobe Retrofit Plate shall be
powered from a non-coded power supply when powered
with horn or speaker. Strobe Retrofit Plate shall have no
measurable in-rush current in excess of operating peak
current. Visual signaling devices are to be installed in all
non-sleeping/corridor and sleeping areas per plans and
specifications. The strobe light shall consist of a xenon
flash tube and associated lens/reflector system. All Strobe
Retrofit Plates shall be capable of mounting to a standard
4″
×
4″
×
1
1
/
2
″
backbox.
Page 2
A05-249-01
SYSTEMSENSOR [ SYSTEMSENSOR ADVANCED IDEAS. ]
