TMCM-3212, TMCM-3213 Hardware Manual (V1.10 / 2016-AUG-24)
10
USB (USB powered mode) if there is no main supply available. This mode may be used for firmware-updates, TMCL-program download
or parameter settings etc. (requires USB connection, only). Please note that in USB stand-alone mode (main board supply available) the
board might still draw current from the USB supply – depending on the voltage level of the USB +5V and the on-board generated +5V.
5.1.4 Input connector
The TMCM-3212 / TMCM-3213 offer four analog inputs (nom. 0..10V range) which may be used as digital inputs, also (+24V tolerant).
The four inputs are available via one 10 pin Molex MicroFit™ connector (Molex part no. 430451012). Mating connector housing e.g. Molex
43025-1000, contacts Molex 43030-0007. Please note that there are alternative options available from Molex for both, mating housing and
contacts.
Pin
Label
Direction
Description
Connected via fuse (polyfuse) to power supply input (+48V_LOGIC
supply input on power control connector). Max. output current
(together with all +48V_FUSE supply outputs on output connector:
500mA / polyfuse protected)
1
+48V_FUSE
Power output
2
3
4
5
6
7
8
9
AIN0
AIN1
AIN2
AIN3
GND
GND
GND
GND
Input
Analog input channel 0 (nom. 0..10V)
Analog input channel 1 (nom. 0..10V)
Analog input channel 2 (nom. 0..10V)
Analog input channel 3 (nom. 0..10V)
Supply and signal ground
10
6
1
Input
5
Input
Input
Power
Power
Power
Power
Power
Supply and signal ground
Supply and signal ground
Supply and signal ground
10 GND
Supply and signal ground
Table 5.3: Interface Brick: Input connector
Copyright © 2015, 2016, TRINAMIC Motion Control GmbH & Co. KG