CONTROL FUNCTIONS - PR PIN
Parallel Operation
sharing but is not fault tolerant. Minus In pins must be tied to
the same electric potential. See Figure 9.
The PR pin supports paralleling for increased power with N+1
(N+M) redundancy and phased array capability. Modules of
the same input voltage, output voltage, and power level will
current share if all PR pins are suitably interfaced.
AC coupled single-wire interface. All PR pins are connected
to a single communication bus through 0.001µF (500V)
capacitors. This interface supports current sharing and is fault
tolerant except for the communication bus. See Figure 10.
Compatible interface architectures include the following:
DC coupled single-wire interface. All PR pins are directly
connected to one another. This interface supports current
+In
+Out
+In
+Out
PC
PR
PC
PR
0.001µF
Module 1
SC
Module 1
SC
–In
–Out
–In
–Out
+In
+Out
+In
+Out
Module 2
(up to 12)
Module 2
(up to 12)
PC
PR
PC
PR
0.001µF
SC
SC
–In
–Out
–In
–Out
Ground plane
Ground plane
Figure 10—AC coupled single-wire interface.
Figure 9—DC coupled single-wire interface.
+Out
Plane
• The +Out and –Out
+Out
power buses should be
designed to minimize
and balance parasitic
impedance from each
module output to the
load.
SC
0.001 µF
R4
2
1
3
–Out
R2
7
R1
Load
LM10
SC
1.05KΩ
200Ω
6
+Out
SC
8
R3
4
L
O
A
D
1.2KΩ
• At the discretion of the
power system designer,
a subset of all modules
within an array may be
configured as slaves by
shorting SC to –Out.
–Out
–Out
+Out
SC
• Do not use output
OR’ing diodes with
MicroMods.
• This module is designed for point of load regulation, where remote sensing
is not required. Active voltage drop compensator, as shown here, may be
used in applications with significant distribution losses. Details of this circuit
are available in the design guide.
Ground
Plane
–Out
Figure 11—N+1 module array output connections.
Figure 12—Voltage drop compensation.
*
PIN STYLES
Designator
Description
Notes
(None)
Short solder
Requires in-board, mounting
L
S
Long solder
On-board mounting for 0.65" boards
SurfMate or in-board socket mounting
Short ModuMate
N
Long ModuMate
On-board socket mounting
* Pin style designator follows the “A” after the output power and precedes the baseplate designator.
Ex. V375A24C600AN — Long ModuMate Pins
Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715
V375C2C50A DC-DC Converter
Rev. 5.1
Page 6 of 8
Set your site on VICOR at www.vicorpower.com
VICOR [ VICOR CORPORATION ]
