D
Manufacturer specified quality class. Quality level is defined by the manufacturers
internal, QML certified flow. This product may have a limited temperature range.
1.2.4 Case outline(s). The case outline(s) are as designated in MIL-STD-1835 and as follows:
Outline letter
Descriptive designator
Terminals
Package style
M
N
T
See figure 1
See figure 1
See figure 1
44
44
44
Ceramic SOJ
Ceramic flat pack
Ceramic flat pack, lead formed
1.2.5 Lead finish. The lead finish shall be as specified in MIL-PRF-38534.
1.3 Absolute maximum ratings. 1/
Supply voltage range (VCC)..................................................................
Input voltage range .............................................................................
Power dissipation(PD)..........................................................................
Storage temperature range .................................................................
Lead temperature (soldering, 10 seconds)..........................................
-0.5 V to +7.0 V
-0.5 V to +7.0 V
1.6 W
-65°C to +150°C
+300°C
1.4 Recommended operating conditions.
Supply voltage range (VCC)..................................................................
Input low voltage range (VIL)................................................................
Input high voltage range(VIH)...............................................................
Output voltage, high minimum (VOH) ...................................................
Output voltage, low maximum (VOL ) ...................................................
Case operating temperature range (TC) ..............................................
+4.5 V dc to +5.5 V dc
-0.3 V dc to +0.8 V dc
+2.2 V dc to VCC + 0.5 V dc
+2.4 V dc
-0.5 V to +7.0 V
-55°C to +125°C
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38534 - Hybrid Microcircuits, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard for Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at http://assist.daps.dla.mil/quicksearch/ or www.dodssp.daps.mil or from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
1/ Stresses above the absolute maximum ratings may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
SIZE
STANDARD
5962-96902
A
MICROCIRCUIT DRAWING
REVISION LEVEL
SHEET
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43218-3990
F
3
DSCC FORM 2234
APR 97
WEDC [ WHITE ELECTRONIC DESIGNS CORPORATION ]
