ISD4002 SERIES
6. PIN DESCRIPTION
PIN NAME
PIN NO.
SOIC /
PDIP
SS
FUNCTION
TSOP
9
10
Slave Select:
This input, when LOW, will select the
ISD4002 device.
Master Out Slave IN:
This is the serial input to the
ISD4002 device when it is configured as slave. The master
microcontroller places data on the MOSI line one half-cycle
before the rising edge of SCLK for clocking into the device.
Master In Slave Out:
This is the serial output (open drain)
of the ISD4002 device. This output goes into a high-
impedance state if the device is not selected.
Ground:
The ISD4002 series utilizes separate analog and
digital ground busses. The analog ground (V
SSA
) pins
should be tied together as close as possible and connected
through a low-impedance path to power supply ground.
The digital ground (V
SSD
) pin should be connected through
a separate low-impedance path to power supply ground.
These ground paths should be large enough to ensure that
the impedance between the V
SSA
pins and the V
SSD
pin is
less than 3
Ω.
The backside of the die is connected to V
SS
through the substrate. For chip-on-board design, the die
attach area must be connected to V
SS
or left floating.
Not connected
1
2
MOSI
MISO
3
11
V
SSA
/ V
SSD
11, 12,
23 / 4
1, 17, 18 /
12
NC
5-10, 15,
19-22
13
3, 4, 13-
16, 19, 21,
23, 27, 28
20
AUD OUT
[1]
Audio Output:
This pin provides an audio output of the
stored data and is recommended be AC coupled. It is
capable of driving a 5 KΩ impedance R
EXT
.
The AUD OUT pin is always at 1.2 volts when the device is powered up. When in playback, the output buffer
connected to this pin can drive a load as small as 5 KΩ. When in record, a resistor connects AUD OUT to the
internal 1.2-volt analog ground supply. This resistor is approximately 850 KΩ, but will vary somewhat according to
the sample rate of the device. This relatively high impedance allows this pin to be connected to an audio bus
without loading it down.
[1]
-7-
Publication Release Date: October 26, 2005
Revision 1.3
WINBOND [ WINBOND ]
