W25Q64FV
7.2.19
Set Burst with Wrap (77h)
In Standard SPI mode, the Set Burst with Wrap (77h) instruction is used in conjunction with “Fast Read
Quad I/O” and “Word Read Quad I/O” instructions to access a fixed length of 8/16/32/64-byte section
within a 256-byte page. Certain applications can benefit from this feature and improve the overall system
code execution performance.
Similar to a Quad I/O instruction, the Set Burst with Wrap instruction is initiated by driving the /CS pin low
and then shifting the instruction code “77h” followed by 24 dummy bits and 8 “Wrap Bits”, W7-0. The
instruction sequence is shown in Figure 18. Wrap bit W7 and the lower nibble W3-0 are not used.
W6, W5
0
0
1
1
0
1
0
1
W4 = 0
Wrap Around
Yes
Yes
Yes
Yes
Wrap Length
8-byte
16-byte
32-byte
64-byte
W4 =1 (DEFAULT)
Wrap Around
No
No
No
No
Wrap Length
N/A
N/A
N/A
N/A
Once W6-4 is set by a Set Burst with Wrap instruction, all the following “Fast Read Quad I/O” and “Word
Read Quad I/O” instructions will use the W6-4 setting to access the 8/16/32/64-byte section within any
page. To exit the “Wrap Around” function and return to normal read operation, another Set Burst with
Wrap instruction should be issued to set W4 = 1. The default value of W4 upon power on is 1. In the case
of a system Reset while W4 = 0, it is recommended that the controller issues a Set Burst with Wrap
instruction to reset W4 = 1 prior to any normal Read instructions since W25Q64FV does not have a
hardware Reset Pin.
In QPI mode, the “Burst Read with Wrap (0Ch)” instruction should be used to perform the Read operation
with “Wrap Around” feature. The Wrap Length set by W5-4 in Standard SPI mode is still valid in QPI mode
and can also be re-configured by “Set Read Parameters (C0h)” instruction. Refer to 7.2.38 and 7.2.39 for
details.
/CS
Mode 3
0
1
2
3
4
5
6
7
8
don't
care
X
X
9
10
don't
care
X
X
11
12
don't
care
X
X
13
14
15
Mode 3
Mode 0
CLK
Mode 0
Instruction (77h)
IO
0
IO
1
IO
2
IO
3
Wrap Bit
w4
X
X
X
X
X
X
X
w5
X
X
X
X
X
X
X
w6
X
X
X
X
X
X
X
X
X
Figure 18. Set Burst with Wrap Instruction (SPI Mode only)
- 43 -
Publication Release Date: December 19, 2011
Revision D
WINBOND [ WINBOND ]
