LT3650EDD-8.2#PBF新到现货!可平均电流模式控制!
日期:2022-11-1LT3650EDD-8.2#PBF新到现货!可平均电流模式控制! 2230只可发货,批次22+,详情15818661396叶小姐
LT3650EDD-8.2#PBF特点:
宽输入电压范围:9V 至 32V (绝对最大值为 40V)
可编程充电电流:高达 2A
可由用户来选择的充电终止:C/10 或板上充电终止定时器
动态充电速率编程 / 软起动引脚
可编程输入电流限值
1MHz 固定频率
平均电流模式控制
0.5% 浮动电压准确度
5% 充电电流准确度
2.5% C/10 检测准确度
NTC 电阻器温度监视器
自动再充电 (在 97.5% 浮动电压)
自动预查验 (在 <70% 浮动电压)
失效电池检测和自动复位
二进制编码集电极开路状态引脚
3mm x 3mm DFN-12 或 MSOP-12 封装
LT3650EDD-8.2#PBF应用:
工业手持式仪器
12V 至 24V 汽车和重型设备
台式托架充电器
笔记本电脑
Use of the timer function also enables bad-battery detection. This fault condition is achieved if the battery does not respond to preconditioning and the charger remains in (or enters) precondition mode after one-eighth of the programmed charge cycle time. A bad-battery fault halts the charging cycle, the CHRG status pin goes high impedance, and the FAULT pin is pulled low.