QCPM-9801 Rev. B Feb 10th 2000 Preliminary
Specification is subject to change with no prior notification
PCS/AMPS Dual-Band Dual-Mode
Power Amplifier Module
QCPM-9801
_____________________
Feat ures
• Operating frequency:
General Descript ion
Package Pin Configuration
(Back side)
The Dual-Band Dual-Mode Power
Amplifier Module (PAM) offers a
highly integrated solution for
PCS: 1850 - 1910 MHz
6
7 8
9
AMPS: 824 - 849 MHz
• Typical Output Power @
3.4V:
CDMA
dual-band
Dual-mode
handsets. The integrated solution
leads to improvements in cost,
size, performance, and reliability.
This PAM also offers several
features that will make handset
design more flexible and robust.
The module contains two power
amplifiers (PCS and Cellular PAs),
two driver amplifiers with power
control and bias circuits.
10
11
PCS : 28.5 dBm
1
AMPS: 29 dBm
5
4
12
13
• Internal 50 ohm matching
networks for both RF
IN/OUT
• 3.4 - 4.2 V operation
( reduced performance at 3V)
3
2
1
Applicat ions
• Wireless Data terminals
• Dynamic bias controls
optimize PAE at low output
power for PCS
The cellular power amplifiers
provides : 29 dBm Pout and 44%
Power Added Efficiency (PAE) at
3.4 V in AMPS mode. While the
PCS power amplifier achieves 28.5
dBm Pout and 28 % PAE at 3.4V in
PCS mode. The PAM is designed
with dynamic bias control to
optimize the PAE at low output
power in PCS mode to maximize
the system talk time.
• WLL
• 11.5 mm x 11.5 mm SMT RF
MultiPak
• Dual Band CDMA handsets
• Driver for Base station
Small SMT Mult ipak
Funct ional Block Diagram
CDMA_Vc
AMPS_Vc
The surface mount RF MultiPak
insures cost, size, and high volume
manufacturing advantages over
other traditional approaches.
matching
network
matching
network
matching
network
CELLULAR
PA
CELLULAR
PA OUT
matching
network
matching
network
matching
network
PCS CDMA
IN
PCS CDMA
OUT