PACUSB-D1/D2/D3
Application Information
The PACUSB-D1/D2/D3 provides a complete interface
for a single downstream USB port typically found in
computers and USB hubs. It integrates the series
resistors (R1) and the 15kΩ pull-down resistors (R2)
for both USB data lines (D+ and D-) as well as the
capacitors to ground for EMI suppression. Zener
diodes provide ESD protection up to 15kV contact dis-
charge per the IEC 61000-4-2 standard and protect the
USB controller on both data lines.
The PACUSB-D1/D2/D3 should be placed on the PCB
between the USB controller and the USB connector, as
shown on the Connection Diagram
Figure 5.
PACUSB-DnY5/Y5R, -DnYB5/YB5R
D+
1
C1
R1
R2
5
D+
USB
CONTROLLER
2
C1
R2
R1
DOWN-
STREAM
USB
CONNECTOR
D-
3
4
D-
Figure 5. Connection Diagram for PACUSB-D1/D2/D3 Devices
To guarantee the best ESD and filtering performance,
it is recommended to physically locate the PACUSB-
D1/D2/D3 close to the USB connector. Also, the trace
lengths between the PACUSB-D1/D2/D3 and the USB
controller should be kept as short as possible.
©
2004 California Micro Devices Corp. All rights reserved.
09/14/04
430 N. McCarthy Blvd., Milpitas, CA 95035-5112
▲
Tel: 408.263.3214
▲
Fax: 408.263.7846
▲
www.calmicro.com
7
CALMIRCO [ CALIFORNIA MICRO DEVICES CORP ]
