欢迎访问ic37.com |
会员登录 免费注册
发布采购

IRL2703S 参数 Datasheet PDF下载

IRL2703S图片预览
型号: IRL2703S
PDF下载: 下载PDF文件 查看货源
内容描述: 1.5 A开关模式电源与线性稳压器 [1.5 A Switch-Mode Power Supply with Linear Regulator]
分类和应用: 稳压器开关
文件页数/大小: 38 页 / 739 K
品牌: FREESCALE [ Freescale ]
 浏览型号IRL2703S的Datasheet PDF文件第1页浏览型号IRL2703S的Datasheet PDF文件第2页浏览型号IRL2703S的Datasheet PDF文件第3页浏览型号IRL2703S的Datasheet PDF文件第5页浏览型号IRL2703S的Datasheet PDF文件第6页浏览型号IRL2703S的Datasheet PDF文件第7页浏览型号IRL2703S的Datasheet PDF文件第8页浏览型号IRL2703S的Datasheet PDF文件第9页  
TERMINAL CONNECTIONS  
Table 1. Terminal Function Description (continued)  
A functional description of each terminal can be found in the FUNCTIONAL TERMINAL DESCRIPTION section beginning  
on page 15.  
Terminal  
Name  
Terminal  
Formal Name  
Definition  
20  
CS  
Current Sense  
Current sense terminal of the LDO. Overcurrent protection of the linear regulator  
external power MOSFET. The voltage drop over the LDO current sense resistor RS  
is sensed between the CS and LDO terminals. The LDO current limit can be adjusted  
by selecting the proper value of the current sensing resistor RS.  
21  
22  
LDRV  
VIN1  
Linear Drive  
LDO gate drive of the external pass N-channel MOSFET.  
Input Voltage 1  
The input supply terminal for the integrated circuit. The internal circuits of the IC are  
supplied through this terminal.  
23  
26  
27  
28  
29  
30  
VDDI  
ADDR  
EN1  
EN2  
RT  
Power Supply  
Address  
Internal supply voltage. A ceramic low ESR 1uF 6V X5R or X7R capacitor is  
recommended.  
I2C address selection. This terminal can either be left open, tied to VDDI, or  
grounded through a 10 kresistor.  
Enable 1  
Enable 1 Input. The combination of the logic state of the Enable 1 and Enable 2  
inputs determines operation mode and type of power sequencing of the IC.  
Enable 2  
Enable 2 Input. The combination of the logic state of the Enable 1 and Enable 2  
inputs determines operation mode and type of power sequencing of the IC.  
Reset Timer  
This terminal allows programming of the Power-ON Reset delay by means of an  
external RC network.  
RST  
Reset Output  
(Active LOW)  
The Reset Control circuit monitors both the switching regulator and the LDO  
feedback voltages. It is an open drain output and has to be pulled up to some supply  
voltage (e.g., the output of the LDO) by an external resistor.  
31  
32  
CLKSEL  
CLKSYN  
Clock Selection  
This terminal sets the CLKSYN terminal as either an oscillator output or a  
synchronization input terminal. The CLKSEL terminal is also used for the I2C  
address selection.  
Clock Synchronization  
Oscillator output/synchronization input terminal.  
34701  
Analog Integrated Circuit Device Data  
Freescale Semiconductor  
4