MB90385 Series
(Continued)
Part Number
Parameter
Delay interrupt generator
module
DTP/External interrupt
MB90F387/S
MB90387/S
MB90V495G
Interrupt generator module for task switching. Used for realtime OS.
Number of inputs: 4
Activated by rising edge, falling edge, “H” level or “L” level input.
External interrupt or expanded intelligent I/O service (EI
2
OS) is available.
Number of channels: 8
Resolution: Selectable 10-bit or 8-bit.
Conversion time: 6.125
µs
(at 16-MHz machine clock, including sampling time)
Sequential conversion of two or more successive channels is allowed. (Setting
a maximum of 8 channels is allowed.)
Single conversion mode
: Selected channel is converted only once.
Sequential conversion mode: Selected channel is converted repetitively.
Halt conversion mode
: Conversion of selected channel is stopped and
activated alternately.
Number of channels: 1
Clock-synchronous transfer: 62.5 Kbps to 2 Mbps
Clock-asynchronous transfer: 9,615 bps to 500 Kbps
Communication is allowed by bi-directional serial communication function and
master/slave type connection.
Compliant with Ver 2.0A and Ver 2.0B CAN specifications.
8 built-in message buffers.
Transmission rate of 10 Kbps to 1 Mbps (by 16 MHz machine clock)
CAN wake-up
8/10-bit A/D converter
UART(SCI)
CAN
*1 : Settings of DIP switch S2 for using emulation pod MB2145-507. For details, see MB2145-507 Hardware Manual
(2.7 Power Pin solely for Emulator).
*2 : MB90387S, MB90F387S
s
PACKAGES AND PRODUCT MODELS
Package
FPT-48P-M26
: Yes
×
: No
Note : Refer to
PACKAGE DIMENSION for details of the package.
MB90F387/S
MB90387/S
s
PRODUCT COMPARISON
Memory space
When testing with test product for evaluation, check the differences between the product and a product to be
used actually. Pay attention to the following points:
• The MB90V495G has no built-in ROM. However, a special-purpose development tool allows the operations
as those of one with built-in ROM. ROM capacity depends on settings on a development tool.
• On MB90V495G, an image from FF4000
H
to FFFFFF
H
is viewed on 00 bank and an image of FE0000
H
to
FF3FFF
H
is viewed only on FE bank and FF bank. (Modified on settings of a development tool.)
• On MB90F387/S/387/S, an image from FF4000
H
to FFFFFF
H
is viewed on 00 bank and an image of FE0000
H
to FF3FFF
H
is viewed only on FF bank.
5
FUJITSU [ FUJITSU COMPONENT LIMITED. ]
