CASES
CASE U MAXIMUM DIMENSIONS
TOP VIEW (PIN SIDE)
Angled corner indicates pin one
.05±5 max ꢀ180213
See Case U ꢁor pin conꢁiguration
10±±5 ꢀ760113 max0
Note: Pins are sꢂoꢃn ꢁor Case U.0
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold
compression glass seal
Case dimensions in inches (mm)
Tolerance ±±0±±5 ꢀ±0.13 ꢁor tꢂree decimal places
±±0±. ꢀ±023 ꢁor tꢃo decimal places
unless otꢂerꢃise speciꢁied
CAUTION
Heat ꢁrom reꢁloꢃ or ꢃave soldering may damage tꢂe device0
Solder pins individually ꢃitꢂ ꢂeat application not exceeding 1±±°C ꢁor .± seconds per pin
Case U maximum dimensions, Rev B, September 27 2±±5
Please reꢁer to tꢂe numerical dimensions ꢁor accuracy0 All inꢁormation is believed to be accurate,
but no responsibility is assumed ꢁor errors or omissions0 Interpoint reserves tꢂe rigꢂt to make
cꢂanges in products or speciꢁications ꢃitꢂout notice0
Copyrigꢂt © .999-2±±5 Interpoint Corp0 All rigꢂts reserved0
5
CRANE [ Crane Aerospace & Electronics. ]
