SpSepceifcicifaictaiotinosnsGGALA2L2V21V01B0
1
Absolute Maximum Ratings
Recommended Operating Conditions
Commercial Devices:
Supply voltage VCC ....................................... -0.5 to +7V
Ambient Temperature (TA) ............................. 0 to +75°C
Supply voltage (VCC)
with Respect to Ground ..................... +4.75 to +5.25V
Input voltage applied ........................... -2.5 to VCC +1.0V
Off-state output voltage applied .......... -2.5 to VCC +1.0V
Storage Temperature .................................-65 to 150°C
Ambient Temperature with
Industrial Devices:
Ambient Temperature (TA) ............................-40 to 85°C
Supply voltage (VCC)
Power Applied .........................................-55 to 125°C
1. Stresses above those listed under the “Absolute Maximum
Ratings” may cause permanent damage to the device. These
are stress only ratings and functional operation of the device
at these or at any other conditions above those indicated in
the operational sections of this specification is not implied
(while programming, follow the programming specifications).
with Respect to Ground ..................... +4.50 to +5.50V
DC Electrical Characteristics
Over Recommended Operating Conditions (Unless Otherwise Specified)
SYMBOL
PARAMETER
CONDITION
MIN.
TYP.3
MAX. UNITS
VIL
VIH
IIL1
Input Low Voltage
Vss – 0.5
2.0
—
—
—
—
—
—
—
—
—
—
0.8
Vcc+1
–100
10
V
V
Input High Voltage
Input or I/O Low Leakage Current
0V ≤ VIN ≤ VIL (MAX.)
µA
µA
V
IIH
Input or I/O High Leakage Current 3.5V ≤ VIN ≤ VCC
—
VOL
VOH
IOL
Output Low Voltage
IOL = MAX. Vin = VIL or VIH
—
0.5
Output High Voltage
IOH = MAX. Vin = VIL or VIH
2.4
—
—
V
Low Level Output Current
High Level Output Current
Output Short Circuit Current
16
mA
mA
mA
IOH
IOS2
—
–3.2
–130
VCC = 5V VOUT = 0.5V TA = 25°C
–30
COMMERCIAL
ICC
Operating Power
Supply Current
VIL = 0.5V VIH = 3.0V
L-7
—
—
—
—
90
90
75
45
140
130
90
mA
mA
mA
mA
ftoggle = 15MHz Outputs Open
L-10/-15
L-25
Q-15/-25
55
INDUSTRIAL
ICC
Operating Power
Supply Current
VIL = 0.5V VIH = 3.0V
L-15/-20/-25
—
90
150
mA
ftoggle = 15MHz Outputs Open
1) The leakage current is due to the internal pull-up on all pins. See Input Buffer section for more information.
2) One output at a time for a maximum duration of one second. Vout = 0.5V was selected to avoid test problems caused by tester
ground degradation. Characterized but not 100% tested.
3) Typical values are at Vcc = 5V and TA = 25 °C
11
LATTICE [ LATTICE SEMICONDUCTOR ]
