MADRCC0002
Dual Linear Driver for Vector Modulators
Rev. V7
Pin Configuration
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Function
NC
IN B
NC
REF B
NC
REF B
NC
REF B
OUT B
NC
Vcc
NC
NC
OUT A
REF A
NC
Pin No.
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
Function
REF A
NC
REF A
NC
IN A
NC
NC
NC
NC
NC
NC
GND
NC
NC
NC
NC
Absolute Maximum Ratings
1,2
Parameter
+V
CC
IN A, IN B
REF A, REF B
Output Short Circuit Dura-
tion
3
Operating Temperature
Storage Temperature
Package Power Dissipation
Control Voltage
Lead Temperature
Absolute Maximum
+20 V
-0.5V < Input < Vcc +0.5V
-0.5V < Input < Vcc +0.5V
Continuous
-40°C to +85°C
-65°C to +125°C
150 mW
300ºC for 10 seconds
The exposed pad centered on the package bottom must be
connected to RF and DC ground. (For PQFN Packages)
Handling Procedures
Please observe the following precautions to avoid
damage:
1. Exceeding any one or combination of these limits may
cause permanent damage to this device.
2. M/A-COM does not recommend sustained operation near
these survivability limits.
3. Additional heat sinking may be required for a continuous
output short circuit to ground, to keep the junction
temperature of the amplifier below 150°C.
Static Sensitivity
Silicon Integrated Circuits are sensitive to
electrostatic discharge (ESD) and can be damaged
by static electricity. Proper ESD control techniques
should be used when handling these devices.
4
ADVANCED:
Data Sheets contain information regarding a product M/A-COM Technology Solutions
•
North America
Tel: 800.366.2266 •
Europe
Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
•
India
Tel: +91.80.4155721
•
China
Tel: +86.21.2407.1588
and/or prototype measurements. Commitment to develop is not guaranteed.
Visit www.macomtech.com for additional data sheets and product information.
PRELIMINARY:
Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.
MA-COM [ M/A-COM TECHNOLOGY SOLUTIONS, INC. ]
