PIC18F6390/6490/8390/8490
12.0
TIMER2 MODULE
12.1
Timer2 Operation
The Timer2 timer module incorporates the following
features:
• 8-bit Timer and Period registers (TMR2 and PR2,
respectively)
• Readable and writable (both registers)
• Software programmable prescaler (1:1, 1:4 and
1:16)
• Software programmable postscaler (1:1 through
1:16)
• Interrupt on TMR2 to PR2 match
• Optional use as the shift clock for the MSSP
module
The module is controlled through the T2CON register
and configures the prescaler and postscaler. Timer2
can be shut off by clearing control bit, TMR2ON
(T2CON<2>), to minimize power consumption.
A simplified block diagram of the module is shown in
In normal operation, TMR2 is incremented from 00h on
each clock (F
OSC
/4). A 2-bit counter/prescaler on the
clock input gives direct input, divide-by-4 and
divide-by-16 prescale options; these are selected by
the prescaler control bits, T2CKPS1:T2CKPS0
(T2CON<1:0>). The value of TMR2 is compared to that
of the Period register, PR2, on each clock cycle. When
the two values match, the comparator generates a
match signal as the timer output. This signal also resets
the value of TMR2 to 00h on the next cycle and drives
the output counter/postscaler (see
The TMR2 and PR2 registers are both directly readable
and writable. The TMR2 register is cleared on any
device Reset, while the PR2 register initializes at FFh.
Both the prescaler and postscaler counters are cleared
on the following events:
• a write to the TMR2 register
• a write to the T2CON register
• any device Reset (Power-on Reset, MCLR Reset,
Watchdog Timer Reset, or Brown-out Reset)
TMR2 is not cleared when T2CON is written.
REGISTER 12-1:
U-0
—
bit 7
Legend:
R = Readable bit
-n = Value at POR
bit 7
bit 6-3
T2CON: TIMER2 CONTROL REGISTER
R/W-0
T2OUTPS2
R/W-0
T2OUTPS1
R/W-0
T2OUTPS0
R/W-0
TMR2ON
R/W-0
T2CKPS1
R/W-0
T2CKPS0
bit 0
R/W-0
T2OUTPS3
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
Unimplemented:
Read as ‘0’
T2OUTPS3:T2OUTPS0:
Timer2 Output Postscale Select bits
0000
= 1:1 Postscale
0001
= 1:2 Postscale
•
•
•
1111
= 1:16 Postscale
TMR2ON:
Timer2 On bit
1
= Timer2 is on
0
= Timer2 is off
T2CKPS1:T2CKPS0:
Timer2 Clock Prescale Select bits
00
= Prescaler is 1
01
= Prescaler is 4
1x
= Prescaler is 16
bit 2
bit 1-0
©
2007 Microchip Technology Inc.
DS39629C-page 141
MICROCHIP [ MICROCHIP TECHNOLOGY ]
