WRB-YD -30W
Series(2
.
16)
OUTLINE DIMENSIONS
&
FOOTPRINT DETAILS
MECHANICAL DIMENSIONS
RECOMMENDED FOOTPRINT
Note:
Unit:mm[inch]
Pin diameter:1.00mm[0.039inch]
Pin diameter tolerances:±0.05mm[±0.002inch]
General tolerances:±0.25mm[±0.010inch]
FOOTPRINT DETAILS
RECOMMENDED FOOTPRINT
Top view grid:2.54mm(0.1inch)
diameter:1.50mm(0.059inch)
TUBE OUTLINE DIMENSIONS
Pin
1
2
3
4
5
6
Single
Vin
GND
Ctrl
Trim
0V
+Vo
Note: The CTRL control pin voltage is referenced to GND
When the environment temperature is higher than
71 , the product output power should be less
71℃,
then 60% of the rated power.
No parallel connection or plug and play.
Use dual output simultaneously,forbid pening
output pin (0V) to use as single output.
Note:
1. The CTRL control pin voltage is referenced to GND.
2. Typical efficiency value at nominal input voltage and full load.
3. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise
specified.
4. In this datasheet, all the test methods of indications are based on corporate standards.
5. Capacitor MAX load tested at nominal input voltage and constant resistive load.
Note:
Unit :mm[inch]
General tolerances:±0.250mm[±0.010inch]
Technical Enquiries-Email:tech@microdc.cn Tel:0086-20-86000646
Page 3
3
of 3